Video Conferencing on ISR G2 PVDM3

[Ahmed Abd El-Baky]

Hi 

I'm working on configuring Video conferencing bridge on Cisco 2921 router , but i can't add the command part : "video homogeneous" in the "dspfarm profile 1 conference " command 

Do youy have any suggestions .

Regards

Ahmed 

[Vivek Batra]

Please check and verify the following configuration;

voice-card x

  dspfarm

  dsp services dspfarm

  voice-service dsp-reservation xx

- Vivek

[Ahmed Abd El-Baky]

Thanks Vivik , they are inserted but i can't also add the reservation command (command unrecognized )

[Ayodeji Okanlawon]

What IOS are you running..

Can you send

sh version

sh diag

[Ahmed Abd El-Baky]

Hi Ayodeji , please find them attached here 

[Vivek Batra · Accepted solution]

You seem to be on 15.1(3)T4 and respective command is available from 15.1(4)M. IMO you need to upgrade IOS else wait if Deji has some other point on it.

- Vivek

[Ahmed Abd El-Baky]

Many thanks Vivik .

Regards

Ahmed 

[Vivek Batra]

Please note that video conferencing is supported since 15.1(4)M till 15.5(3)M. On which version you are?

http://www.cisco.com/c/en/us/products/collateral/unified-communications/tdm-gateways/bulletin-c25-735945.html

- Vivek

[Sreekanth Narayanan]

Ahmed, please note that Video conferencing and transcoding on the PVDM3 modules is not longer supported by Cisco. The alternative solution for the customers now is to move to the Cisco TelePresence Multipoint Control Units (MCUs) which are being marketed as the solution for video conferencing and also support transcoding.

[Ahmed Abd El-Baky]

Hi Sreekanth

Thanks , i got that response from them .

http://www.cisco.com/c/en/us/products/collateral/unified-communications/tdm-gateways/bulletin-c25-735945.html

even they gave it a bug ID : CSCus97643

Regards

Ahmed