Network Access Control

Cisco Access Control Server (ACS), Identity Services Engine (ISE), Zero Trust Workplace
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

Labels

Forum Posts

Hi Guys, i have configured a suest porta integrated with aziure SSO.I followed this link: https://community.cisco.com/t5/security-documents/ise-byod-flow-using-azure-ad/ta-p/4400675 if i test from portal test it looks like working fine but if i try f...

Xeladona by Level 1
  • 5082 Views
  • 6 replies
  • 5 Helpful votes

HiSo basically I have this problem I have eve ng VM and inside of it I'm installing ise primary node and secondary node and AD so I configured a NAT pool on the router and I control those equipements with internet addresses, so now I make a MGMT PC a...

Jason2005 by Level 1
  • 594 Views
  • 2 replies
  • 0 Helpful votes

SW2(config)#aaa server radius dynamic-authorSW2(config-locsvr-da-radius)#client 192.168.100.210 server-key Test123SW2(config-locsvr-da-radius)#client 192.168.100.220 server-key Test123Those commands means that we set AAA server (ISE1 and ISE2 in this...

Jason2005 by Level 1
  • 3499 Views
  • 3 replies
  • 0 Helpful votes

Can someone please explain to me those commands ? SW2(config-if)#authentication host-mode multi-authSW2(config-if)#authentication port-control auto@dot1x Troubleshoot Dot1x and Radius in IOS and IOS-XE Configure Secure Client NAM for Dot1x Using Wind...

Jason2005 by Level 1
  • 1720 Views
  • 3 replies
  • 0 Helpful votes