Network Access Control

Hi, I restored config ACS and later we upgraded to 5.5 patch 11. Before doing this we received mails when backup and DataBase purge were done. But since we did this restore and upgraded from 5.5 patch8 to patch 11 we dont receive these mails. Where ...

Hi all,quick question about scaling with ISE 2.1 and 3595-Appliances: According to documentation a 3595-Appliance can serve up to 40.000 concurrent active endpoints. So if I had a pure centralized deployment (all in one datacenter) and if I had perfe...

Hello, Does anyone have a experience in testing radius server availability? I what way the switch can test radius server availability and what action it will take after detecting server is dead? Setup is done with ISE 1.4. 

We would like to know if ACS 5.7.0.15 is compatible to WLC 8.2.110.0

Hi,In the default sponsor portal view there is a SSID: option which can be filled for the configured SSID.Based on which a sponsor portal user select for this SSID fields allows the user to be connected to.In the ISE policy options I did not found a ...

Hi everyoneWe have a customer, about 10 libraries, that use Aerohive in concert with and Integrated Library System (ILS) to perform authentication off wlan, and provide granular access based on the type of user. Sounds like an ISE use case, but I won...

Hi there,Appreciate your guidance on the following:Customer has a use case where 2 users may log into one VM at the same time - so concurrently logged in - and have asked whether it is possible to assign an SGT to each user.If a single user was logge...

Is there any change for the maximum RTT between ISE nodes for v2.1?