Network Access Control

According to http://www.cisco.com/en/US/prod/collateral/routers/ps5853/prod_white_paper0900aecd806c6d65.htmlMAB is supported on the 1841 with an HWIC-4ESW "Layer 3 Only."Isn't MAB by definition a layer 2 process? What on earth is Layer 3 MAB?Thanks.

Is it possible to set up a multi use port that will use dot1x to authenticate several laptops, only 1 connected at a time, but I need the phone to automatically connect without having to make changes to the phone config as I don't have access to the ...

Hello,I've installed on my ACS appliance the following patches:5-1-0-44-15-1-0-44-25-1-0-44-35-1-0-44-4The installation of the fourth one was interrupted - I don't know why - and since then, the Process 'runtime' shows the status Execution failed or ...

I have been trying to figure out for days now how to get Windows XP/Windows 7 and Apple iPads to connect to a broadcasted SSID and authenticate with PEAP without getting prompted to verify a certificate that exists on ACS.In Windows 7, I get a window...

Dear All,I'm completely new to NAC solution. We have an urgent requirement coming up from a customer for NAC implementation. It's an Enterprise network consists of DC, scaled down DR, Head office and various Remote offices. They have already purchase...

    Some how there is an access restitction to my NAC box thorugh http. I can access this box via ssh. Please suggest me how do i configure the device using ssh for http accesss.https://10.48.252.65/adminthe error message when i access through http i...

The client machine that I am testing with is authenticating fine, but I am not able to get it compliant with posturing policies.The client machine is windows 7, running nac agent 4.9.0.42 and compliance module 3.5.4.1, against ISE 1.1.1I have configu...

Hi,I get the Guest portal page and my credentails authenticate correctly and the device is authenticated using MAB. Then i get this messageThis device has not been registeredYou need to manually configure your deviceYour device configuration is not s...

We have AAA configured as followsaaa new-modelaaa authentication login default local group radiusaaa authentication enable default enableaaa authorization exec default group radius if-authenticatedaaa session-id commonIt was expected that switch will...