Network Access Control

I'm using Cisco ACS 3.3 for RADIUS. How to do I make Vendor-Specific attribute available? (Attribute number 26, format: OctetString)The online help makes reference to it, but does not tell you how to make it available.

Good Afternoon,I'm looking for a way for users to authenticate through the ASA to determine whether or not they are granted access to the Internet. I would like to provide two separate Active Directory groups, for example, GRP-NO-INTERNET and GRP-INT...

Hi folks,I am configuring some of my devices to use CHAP when their backup ISDN interface dials out to the 7200 concentrator node. I wan the CHAP requests to hit our ACS 5.2 appliances and be authenticated via this method. I have built a rule for 'De...

Hi everyone, I have ISE VMWare based. Every time, when I switch the power of the server off for any reason, and turn it on again, I lose the connectivity through HTTP to the ISE but I can still ping it !!!! I couldn't know what was the issue and for ...

Hello sirs,Could you please answer a little question. Is it possible to track failed login attempts to ACS instances  (both on CLI and web GUI) by snmp? Unfortunately i haven't found such option in Monitoring and Reports > Alarms > Thresholds >

Doesanyone have a working example of using ACS 5.1 to authenticateBigIP LTM GUI users?  I have found a couple of discussion in the F5 devsite but nothing using ACS, only generic TACACS+ implementations.

Guys,Bit of a strange problem here that just started last week - basically I tried to logon to our ASA and I was denied access, thought that's strange but tried a few times and got some other people to do the same - on doing so they also failed. I tr...

Hi,I've set up ezvpn using DVTI for both hardware and software ezvpn clients on on a IOS router. Authentication authorization (mode config) is done with RADIUS towards ACS 4.2, and this is working fine.In order to get this to work, I had to create us...

Hello.I need to limit to some AD groups, authentication with ACS 5.3For example, i need that only users os somedomain.com/users/test1 are authenticatet via ACS --> ADSomeone can give me hints or help or links that explain me the correct configuration...

Am i right, that UCP can not run on ACS directly? I must setup an extra webserver for this? Will this change with 5.4?

Hello guys,I'm not quite sure do I post within the right thread so please correct me if I'm wrong.Anyway, the problem is as subject says - Problem with installation of wildcard certificate on Cisco ASA 5520 (VPN Plus license). Software version is  8....

Thanks,

Hi friend,culd you help me about ... what mean the picture attached  about ntp configured in my acs.Thank.Marco.