Network Access Control

Hi friend,Someone could you help me .. I need to kown if it is possible to implement Cisco ACS 4.2 with Remote agente installed in Windows 2003/2008 integratedwith AD Which ins installed in Windows R2.Best Regard,Marco.kown

Hello Guys,I have been in very trouble with this NAC since last week, it started when there was power outage in datacenter and both of my NAC Servers went down.After restart, now clients (Nac agents) are not switching to Normal VLAN from Authenticati...

HIhow to link the command set to a shell profile in acs 5.2.thanksAntero

Hi team,we have setup of two appliances of Cisco Secure ACS. We need to implement in HA mode both.We have register secondary with primary. But when primary goes offline then not able to view logs on secondary. Able to authenticate with devices.How we...

HIi have access point with tow SSID one for staff and the other for students,i m doing MAC authentecation . lets say that staff is accessing vlan 10 and student going for vlan 20.i have tow groups on the ACS group1 with staff MAC address , Group 2 wi...

Hi,I want to use EAP-TLS with my shiny new certificates issued by my new Windows CA, and what happens? Nothing works.I don't have a clue what I should do. I try to establish a EAP-TLS connection using my Windows CE mobile device, but my cisco AP541N ...

Hi Pros,Having an issue with an 881 I have recently acquired. I'm wanting to setup a Virtual Office scenario. Everything is working fine except for 802.1x...I can get the 881 to authenticate things connected to it, but I don't have the options of gue...

Having an issue with Cisco ACS v5.1.0.44 and the Cisco WLC 5508. Cannot get users to authenticate and keep getting error messages referring to EAP session timeouts from WLC filling our logs. Seems to be with this model WLC because we have Cisco 4400 ...

Hello Everyone,I have two ACS 5.2 running as primary and secondary instances respectively.  When I try to delete a remote log target under System Administration > ... > Configuration > Log Configuration > Remote Log TargetsI get the following error m...

I'm trying to assign a particular group certain QoS values in ACS 5.2 using the authorization profiles.  Under Policy Elements > Auth. And Permissions > Network Access > Auth. Profiles > Common Tasks in the QoS Input and Output Policy Maps, if I add ...

Here is a snippet of my proposed config for LDAPaaa group server ldap AD server TESTSERVERldap attribute-map ADTESTldap server TESTSERVER ipv4 192.168.0.20 bind authenticate root-dn testuser password testpw base-dn DC=testdomain,DC=localThe username ...

I have installed ACS 5.2 on a VM. The install seemed to go ok as did the set-up procedure. However the management process will not start it always stays in the initialising state and thus I am unable to load the web GUIThe VM has the following config...

Only one question for me. Struggeled to find the answer in any documentation. In the new 4.9 release for NAC: when deploying OOB L3: Will wireless users and wired users be able to connect to the same CAS. Wireless LAN controllers for the Access Point...