Network Access Control

I am getting ready to install a new ACS 5.1 server to replace my current 4.1 acs box. I wanted to start off with a fresh install rather than upgrading all of my 4.1 data.Can I have devices (ASA for VPN authentication, routers & switches for user auth...

Hi Gurus,I have deployed a Cisco wireless environment at one of our sites. The problem is that we are rolling out new motorola handhelds (MC75) are not authenticating with the ACS. I have copied the same config as it was with the exsisting  wireless ...

Folks,I have an issue with an implementation, I had a ACS R5.1 that I'm using to authenticate the wireless users with 802.1x, that's OK and working fine. Now I want to use the same ACS to authenticate wired users using MAB (for IP phones, printers, s...

Hi, I m using ACS for Authentication, Authorization and Accounting. I dont want accounting for SHOW commands. Can any one suggest the requisite commands to be configured on cisco router or switch so that SHOW commands will not be accounted?

Hi,Need help with Cisco Secure ACS 4.0

I cannot get login working via TACACS from my Nexus 5548.  I've tried creating a group and a single server with key etc.Config is simple:tacacs-server key 7  ************ip tacacs source-interface Vlanxaaa group server tacacs+ tacacs    server 10.x.y...

Hello MembersI am running ACS 5.1 (on VMware platform), just stouck up with the requirement mentioned below.Existing Setup # Wireless guest users at present are authenticated against ACS 5.1 local database, client wants they should be time based, for...

Hello,I am trying to determine how I can assign a static IP to a user in ACS 5.2. I am able to do it in ACS 4.2, but I don't see the same options under 5.2.General idea is that users authenticate from our VPN appliance via RADIUS, and upon authentica...

Just upgraded from 4.0 - to 4.2 then to 4.2.1 15. As you may have seen with periovous posts of mine its not been an esay ride.I have now managed to get it all working - backups AAA etc but for some reason i cannot get the replication to work! Its sta...

Good morning my fellow Cisco users!  I have Dot1x set up (with certificates) and running to the point that im almost ready to put it into my production network!  I have one thing im trying to work out that I hope is doable. On my test port I haveswit...

Hi all,I was wondering on one thing regarding ACS deployment with multiple instances.To simplify this let us consider that- there are only 2 locations (HQ and Remote, each with its own ACS, AD controler, DNS service)- ACS are in HA  (in HQ is primary...