Network Access Control

Hi,Please help me get the serial number of our ACS. We need to find the serial number for TAC. Thank you so much guys.

Could someone please provide me with a simplest set of configuration steps to fire up Radius in ACS and 802.1X for dynamic vlan assignment. The objective is to roll out NAC L2 OOB using the 802.1X method for dymamic vlan assignments. If possible show...

HiI am using Cisco acs  4.1 build 23 windows version software now i am planning to upgrade to 4.2 version .While checking some release notes document i am seing the below details .Ordering InformationTable 1. Ordering Information for Cisco Secure ACS...

Good morning everybodyI'm running ACS 5.2.0.26. Since some times I have a extremely high memory utilization of about 86%. The latency of RADIUS responses is between 10 to 12 ms.Is this utilization factor normal behaviour ? If NO, what could be reason...

HelloIs it possible to force the ASA to treat traffic that it must perform AAA authentication on port 81 as web traffic?I've tried the following:access-list outside_authentication_LOCAL extended permit tcp any interface outside eq 81aaa authenticatio...

Dear Friends,I have two VPN concentrators and ASA 5580 appliances and i'm using both platforms for IPSec VPN termination and also we installed Cisco ACS 5.2 appliances.My question is:what is the best way can i do the authorization (where the users ca...

I am trying to find some documentation if and how this is done on the 1941 ISR. I am not too familiar with the new CCP tool.

I work at a University and for some reason we have multiple systems for authentication and authorization.  That being said I am trying to use radius to do authentication and AD for authorization for VPNs.  I have the radius authentication working aga...

What would my AAA config look like on an ASA...and on my ACS server (CSACS 4.2) if I wanted administrative ssh connections to the ASA to be authenticated against one directory (via tacacs) and VPN users connecting to the ASA to be authenticated again...

Hi all,I've defined 802.1x on all access-ports of our Catalyst 3560 (12.2.(53)SE2.Everything works fine until it comes to PXE. I see from traces and "show"-cmds that the client using PXE is moved from the data-vlan (vlan_id 4) to the guest-vlan (vlan...

folksi want to use an acs appliance i have for tacacs authentication for both juniper and cisco devicesmy issues is that i use the same username but differnet passwords for juniper and for ciscois it possible to use the same username but different pa...