Network Access Control

Please refer to the attachment "error.JPG". When i launch the setup.exe, it show me the error message. Seem like the setup file is created for 16bit OS. Anyone can help?

Recently I have updated the IOS on my 6509 switches. After upgrading when ever I am trying to entering into privilege mode, switch is giving username prompt rather than password.

I have configured TACACS and I am able to logon to cisco devices successfully using TACACS user ID and password. I need to create another group ad assign users to new group just to run SHOW RUNNING-CONFIG command only.any idea?Regards

I have seen ACS sending emails to users saying that your password will expire soon. Please change your password using the link given below. When we click on that link we will get an ACS webpage just to change the password. Can you explain me how to e...

Users who has logged into the switch or any cisco devices are not able to execute any commands(error:Authorization Failed).The same users can execute those commands in switches once they logout and relogin to the devices.This is happening frequently....

Hi I have ACS appliance 4.2.0.124 installed at 2 sites. In one of the Appliance, under (Not Assigned) NDG the AAA server was reflecting as Self with IP address 127.0.0.1 & with the other one under AAA servers exact ip address of the appliance was ref...

Hi,I have configured remote access VPN (IPsec) in my Cisco ASA . Before there was only single username & password to for VPN client. Now I am planning to give access through RADIUS server. I have configured RADIUS server in WIN 2003 server.Server con...

hi all i have one VLAN configured for wireless.is it possible to authenticate wireless users thru html page when they try to access the internet?.wireless VLAN is configured on Cisco 3560 switch.If possible please give me one sample configuration.Tha...

Hi all,I have setup Cisco secure ACS in my office. Issue is authorization. I want to give granularity to different users like some users needs to execute only some commands in previleged mode (eg: mpls traffic engineering re-optimize tunnel). I was t...

Hi, I need authenticate the wireless users in AD and to make this i use 1 WLC and ACS SE 4.2. I already configure ACS SE and installed Remot Agent(4.2) in Domain Controller. The problem is that a can't authenticate. The ACS SE erro sad "internal erro...

I am implementing "AAA for network access" where in each user is displayed a login page by the ASA to browse the internet.I am using RADIUS for this through an Cisco ACS. the problem is even if i limit number of simultaneous logins for the user to 1 ...

Can I use Funk Radius server for authorization? Has anyone done this in the past?Thanks!John

Please I have a domain which my ACS on win 2000 server is part of. I am trying to point the ACS to the user datbase on windows,please tell me the basic config. if you must reffer me to a user guide, please tell me the part and page.