Network Access Control

Hi friends my customer has ASC ver. 3.3.3 as primary at windows server and secondary is new and ACS 4.0 is installed on it but is free from data.Qes : they asking if we can replicate the database between primary acs 3.3.3 and secondary 4.0 then afte...

I have IAS running on W2k3 Active Directory. I have tested sucessfully set up 2 group of users called Level1 and Level15 logging in to routers. Level1 gets privilige 1 while Level15 gets 'enable mode'. What I want to do next is set up IAS so that ...

How I can add (define) a new Radius attributes to my Cisco router , thanks a lot for your helping

Hello friends...I am trying to implement 802.1x in my network, but I have a problem.I have an environment with Cisco ACS appliance 4.1.2.12, switches 3560 12.2(37)SE1 and clients Microsoft Windows XP and 2000.My problem is: I want to implement Machin...

Hi, allThe problem is that I want to configure a local database on the ASA in order to authenticate WebVPN users, but it looks like ASA is using the same database for authenticating users for SSH access. Is there any way to define which users are goi...

after upgrade of acs 4.1 the tacacs+ administration( on reports section) database does not populate with commands that administrators enter on cisco routers.any ide ?thanks.

HiSo we've just done an upgrade of CSACS 3.3(1) to 3.3(3) and then from there to 4.1 as recommended. After the upgrade, all 'seems' to be fine with the server, all the services have started and seem to be running, the UDP ports are open (1812, 1813,...

daer i have enabled AAA on my AS5400 to start clients to authenticate with softsitch and Raduis server.... i did not capture any raduis packet from AS5400 at raduis server.....what is the problem:aaa authentication ppp default if-needed group radiusa...

I see multiple attempts to conncet to my VPN server. We have the server setup with group user name and passwords. It then authenticates the user to ACS. I see multiple login names from one ip. Root, wireless, admin, and many many others. How can i ad...

Hi,We have cisco router IOS 12.4 setup forAAA authetication login default TACACs+...telnet login works fine ...with the TACACS+user...we also haev aaa authetication enable default TACACs+ configured and allowed cisco pap password for user...now when ...

I'd like to know if anyone could identify the cause for the following?We run two Secure ACS servers v4.1.3.12 (patch 2) one as primary and the other as secondary. This issue also occured in v4.1.1.23. They have no issue with replication between the...

Hello,Is there a document with ACS error codes (occuring in log) explanations? I've found only the document with ACS error codes list.Best regards,Krzysztof

folksi have an existing windows server running acs software (v3.2)it is used for cryptocard authenticationi want to migrate the service to an 1113 applicance running 4.1 - this includes the cryptodbaseany one any good documentation on how to do this?...

Hi,We've successfully upgrading ACS 3.2.1 to 3.3.3 then 4.1.All remote access works perfectly, so no trouble for the end users.Therefore we've a problem to edit downloadable ACL's.I can access to the "Downloadable IP ACLs" panel but when I click on "...