Network Access Control

We are developing an ISG Radius CoA client.Our settings are: * Cisco IOS Software, 7200 Software (C7200-K91P-M), Version 12.2(31)SB6, RELEASE SOFTWARE (fc1) * Here is a snippet of our configuration for CoA: aaa server radius dynamic-author client 192...

when a computer firstly connects to network it asks prompts for user pass for 802.1x authentication. but after restarting the computer or logging off and logging in again it doesnt prompt. when I check the cisco ACS for passed authentications I see t...

I have authentication set up on my 3745 router. Installed in my router is a 16 port a-sync card. The line numbers on the async card are 65 through 80. I do not want authentication turned on for those lines.I have tried "no login authentication" for e...

Hello,how do I authenticate two SSIDs against one ACS. Users from SSID A should not be able to log onto SSID B and the other way around.The proble here seems to be that for the ACS both SSIDs are authenticated by the same NAC/WiSM/Source IP address. ...

anyone had any success doing this?I've been following the suggested config at http://www.cisco.com/en/US/customer/products/ps6566/products_feature_guide09186a0080610dad.html#wp1058626 but not having any success.sessions terminate on my 7301 via L2TP ...

I am trying to implement Cisco's AuthFail VLAN functionality on a Catalyst 3560. It works fine with PEAP but does not work with SmartCard/Certificate (EAP-TLS) as the 802.1x protocol.Please note that in my scenario I expect the authentication to fail...

I have a primary ACS with IP address 10.250.97.29/24. it is working fine.Now I would like to add a secondaryACS with IP 10.250.97.50/24. BothACS 4.1 are identical with version 23 patch 5. both are running on Win2k3with Service Pack 2. Both Win2k3 are...

Hi,I need to activate a control privileges of users on various devices.I found this interesting document:http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00808d9138.shtmland using a router with IOS 124-11.XV1 ...

HiI have Pix firewall which configure AAA to ACS. I have Also ACS 2.3 in Sun based.I create two group in ACS. in group A has user like jon, sam bin and group B has user like shn , kell. now I permit autentication user group A to firewall. from group ...

We have one ACS server on the network and we need to add a second server. The secondary server will be replicating the primary.Is it advisable to point some devices to the primary and the other half to the secondary server to balance the load? JT