Network Access Control

I am struggling with a customer requirement...They require a remote access VPN solution, which connects back to three locations -Scotland, London and New York (using ASA's or their existing PIX 515e's). The users are geographically dispersed around t...

i have a acs appliance configured with a remote agent on a windows 2003 domain controller. I have followed the install guide and setup the permissions and accounts in AD. On the ACS the remote agent shows up and connected. When i try to authenticate ...

what is the appoximate cost of ACS 4.0(or the latest one) version and is different from an upgrade from 3.3?

Hi,I?m running Cisco Secure ACS v.3.3 at Win 2000 server(sp4). ACS server is member of AD domain X. Additional there are two AD forests, so: domains X and Y are in the same forest, but domain Z is member of the second one. Trust relationships between...

Hi All,I installed a self-signed certificate on the ACS solution engine running 3.3(3). I enabled https access for admin access. I do not have any restrictions as far as connecting IP. But when I try to connect, IE says "page cannot be displayed". Ho...

I have made lots of customization on my ASA 5540 box and would like not to have to spend the time doing it on the second box. Is there a way to copy all the customization made in the ASDM to a new ASA 5540?

hii have an ACS 1113 ....i have installed and configured the certificate... and trusted the CA certificate... also i configured the global authentication (enable the PEAP ,EAP-TLS)no when i try to authenticate (by the wireless) i get failed to authen...

I have tacacs ACS 3.3 I would like to deploy for large enviroment, about 500 network devices. What would be the optimal server requirements for this? and do I need to upgrade to ACS 4.1 or stay with 3.3?Thanks

Hi,I successfully upgraded our ACS SE 3.3.2 to 4.1.3.12. First, I upgraded the SE from 3.3.2 to 3.3.4. After upgrading to 3.3.4, I upgraded it immediately to 4.1.3.12. The upgrade was successful. However, the login page still displays 3.3 and the Hom...

Hi allQuick question about my NAC setup on the ACS appliance.I have create a number of Network Access Profiles from the templates that ACS provide. All is working fine but my question is in regards to the Advanced Filtering under the NAP.When I creat...

Hi,When i was reconfiguring the ip address of my ACS applicance using "SET IP" command, it failed to assign ip address, i rebooted the appliance since then whenever i try to configure ip address on it using "SET IP" address command, it gives me follo...

Hi there, I was wondering if this has happened to anyone here. I have a Windows 2000 Server running ACSv3.2 - Once every 4 months ACS will fail to authenticate all the wireless users that have Active Directory accounts. Auth-Failure code: ?External D...

What caveats can I expect when implementing 2 factor authentication, for RAS users dialing in when using RSA and ACS? Users are authenticated via Active Directory from ACS, so password expirey for them is required.I'm having trouble finding documenat...