Network Access Control

Hi folks.While looking at the "Failed Authentication" report I have a log entry that occurs so frequently that it blocks out 'real' authentication failures. The log entry always includes the keywords "host/" (no quotes). The ACS filter allows you to ...

Maybe you can help me here. I'm currently testing ezvpn connectivty into our MPLS network for our clients remote access LAN-to-LAN VPN. This is working fine, but I have an issue with two things.First, can I assign an IP Address to a client based on t...

hi i was trying to configure auth proxy in my router .. with acs using tacacs+.. but somewhere the authentication was failing..i had configured acs as required and i dont find any problem with it as it is succefully working with http auth proxy..conf...

folksi have a vpn connection coming into my network which i'm passing onto a third party networkwe use radius to authenticate our own users but the new connection uses the third party's authentication server(SecureID - i think) and they now want to o...

two SACS1113 act as AAA server,the same config,one can authencate,the other can't . the aaa client's debug authencation information .3_lou_3550# debug aaa authenticationAAA Authentication debugging is on3_lou_3550#ter mo3_lou_3550#ter monitor3_lou_35...

We are in process on migrating over to an ACS appliance 4.1. I have downloaded updates and have launched the autorun.bat file. After running the update to 4.1.3.12 CSAdmin fails to start. Tried starting it manually via serial port, but no luck. The p...

Hi, Can anyone help me to locate a AAA server that can do complete EAP-AKA authenticaion. I assume they have AAA + HLR sumulator? Appreciate if someone can guide me.Thanks,JAgan

Hi,Kindly help me in installing and configuring ACS 1113

I've created a Net Dev Group with my new group name, then added two pix clients within. I then go to Group Setup and expect to see my new group in there (so that I can apply authorization) but my new group name does not appear. We have 18 groups buil...

Hi.I've logged the router provided by the ISP of mine (of course, with the a userid provided). I noticed that i can perform a "show running config", showing however only a partial configuration of the router (ACL, AAA, services running arent shown), ...

Shortly we began tests with VOIP, these devices authenticate using CS AAA server.In the logs of our NAS we find the following messages : May 30 07:35:58 [10.2.51.99.227.50] 5: May 30 07:35:57: %RADIUS-4-RADIUS_DEAD: RADIUS server 10.2.19.202:1645,164...