Network Access Control

Hello Team,I'm facing a problem with user access control on my WLC WIMS2.I want to limited access for BYOD to 3 devices per account. But i have notice that there is no control on the username case sensitive. My configuration is that i have the WLC wh...

Hey all, does anyone know if a backup on ISEv2.0 and restore on ISEv2.7 is supported or not? The documentation I read wasn't clear-cut. Note: For the software upgrade process, I know that you cannot jump from ISEv2.0 straight to ISEv2.7 (you must go ...

Team,I am working on ISE opportunity where I am doing ISE posture for VPN users. Posture for VPN users is working on windows workstations but it is not working on MAC machine. I am getting message "no policy server detected" I tried following on MAC ...

I'm trying to create a local ssh read-only account and set it up on Secure ACS, but haven't had any luck. I've created a user, but the credentials don't work. Suggestions would be greatly appreciated. I would open a TAC case, but support has expired....

Does anyone of the correct JSON body required to update a static SGT mapping via REST.  Here is what I am trying:   I am doing a JSON PUT to my admin node: https://10.0.128.237:9060/ers/config/sgmapping/17a7afe2-b3e5-459c-8090-587ed1fb3381   The bod...

I have configured AnyConnect and the VPN connects etc, my question is, where does AnyConnect pull its routing table from and is it possible to add routes? Also, is it possible to change the default GW that it assigns to clients?

Hello Everyone I have at home for learning purpose an ISE installation together + a Cisco Catalyst 2960-x. I did not work on these devices for the past few days... so I didnt changed anything. Today I started the LAB again, and when I wanted to conne...

Hello, Can someone give the steps to enable ssh access in cisco ACS. I am the administrator for cisco acs and I can login into the gui without any issues but when I login via ssh it says access denied. Cisco Secure ACS Version : 5.6.0.22.2 Thank yo...

I have turned on the aaa command authorization without applying adequate privileges to the user. I can now login through that user but the ASA 5510 displays an error :============================EUKFW2# show running-config ^ERROR: % Inva...