Network Management

Hi. I've set up the ACS to forward via syslog to CW, and manually added ACS as an unknown device in RME.In RME, I tried to set up automated syslog action to send ACS syslog messages via email, but RME doesn't seem to want to action upon.All the other...

Hi mates :)I need some ideas please...please see attached "seed_device.jpg" file. This figure shows my overall network diagram.My question is: According to the figure, which active device should I use as seed device when I configure seed device on LM...

I have a tftp server on a 10.20.0.1 network my router is on 10.40.0.1 network. I can not ping the tftp server. What Am I missing ? There is a ASA firewall in place with acl's setup for each sub net

Hi,I am upgrading the Ciscoworks Common Services from 3.0.5 to latest which is 3.0.6I am now running into issues that will not allow the successful installation of 3.0.6Error:===============process. You must stop all processes listed below toproceed ...

I am working on mapping out our network using Visio 2003. I noticed MS had a AD diagrammer program that was pretty painless to run. Are there any equivalents like that for Cisco that work with Visio?

how manually entered device on LMS 2.6?we have lmited licence so we turned of auto dicsovery. we only wants added important device on ciscoworks. like router and switches not access point like that.please any advice I'm new. thank you in advance for ...

Does Cisco ACS require a purchased license?If so,We have an existing ACS for our TACACS authentication, can you legally use the same license for a backup ACS server?Can you set up multiple ACS servers like Primary/Secondary?

I have an older LMS 2.6 server and a newer (evaluation) LMS 3.0 server, both have the latest patches installed (available on CCO). When I use an XP client with IE 7 and the latest Java 6 plugin installed I can sucessfully access Topology services on...

hi mates :)I have 4 switches in LAN and some switches and routers in WAN locations. All have IP connectivitiy to LMS 2.6.is it possible to get a picture of overall network diagram using LMS 2.6 ?

We need to install device package of Rtr3800.cv50.v8-0 but when we install from command line it gives error asMCP IS NOT INSTALLED.yOU NEED TO INSTALL mcp 2.0.2 TO RUN THIS SCRIPTHow to install this MCP .... can u give any link on cisco to download t...

Following an attempt to get rid of some old events in DFM that would be "replayed" after every Ciscoworks restart I tried to delete the entries from the DFM databases by initialising the databases using the following commands:-1) net stop crmdmgtd 2)...

Hi, I'm currently running out space on C drive where my Ciscoworks was installed. I'm having problem backing up from the GUI due to insufficent disk space. Is there any alternative backup method ?Thanks.Joseph