Network Management

Are there any processes to analize the dhcp pool interface on a cisco router?

Hi All,Currently we have a 4507R configured as our core switch, it has been installed with the following modules.1 Supervisor II+ 1000BaseX (GBIC) WS-X4013+ 2 Supervisor II+ 1000BaseX (GBIC) WS-X4013+ 3 10/100/1000BaseT (RJ45) WS-X...

I haven't done anything with Network Management for about three years and my last installation was Cisco Works with LMS, DM, CiscoView. I now have to spec out an enterprise management package for a 400 employee company for their LAN, potential small...

Hi, ALL!!!Friends, I have a problem with my Cisco Router 2610XM. I configured it as Console Server with ASYNC module. And all my Cisco device works perfectly, I mean that it's console port connected with ASYNC module on 2610, and now my company buy H...

The automation between CM and DCR appears to have stopped working on our CiscoWorks.Changes made to the DCR are not reflected in the device list in CM, and new devices discovered by CM are not being added to DCR.Where do i check the settings to ensur...

I apologize if this is an off topic conversation, but failing to find any particular forum to address my question, I shall endeavor to keep it short and to the point here. I want to prepare a document for my Network Operations Center to include such ...

HiI add VPN concentrator in my VMS bundel Performance monitor. Here i can see cpu utilization but no BW utilization and event viewer so what i do in my concentrator.thanksBiplob

Has anyone had problems with ver 5.2 of Network Assistant with the CDP neighbors not showing up in the topology window? In version 5.1 it seems to work find but when I upgraded to ver 5.2 the cdp neighbors will not show up in the topology window.

(*Sorry to be long winded, but I guess detail counts*)We had the perfect storm...network wise anway. Our cumpuattional culster was doing a huge data-push, while there was a deep SARA scan going on. The little 4003 was not able to take the beating f...

From the very beginning after upgrading to LMS 2.6, my RME->Archive Mgmt->Configuration Archival Summary shows a total of only ~25% of the total Normal Devices of RME inventory. This is affirmed by a Device Status Report, showing Inventory Collection...