Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Hi,   I am having issues with PI after upgrading it to 3.4.0. Before I used to get email alerts when wired network devices are unreachable but now I am not getting the alerts.  I also noticed that when the switch is down, I can still see the Reachabi...

Hi there,           I want to setup send syslog from a router(public ip) to SNMP server(private ip). I've successful setup sending syslog from another router(private ip) to snmp server(private ip). Do I need to do special configuration on firewall or...

PolarPanda by Beginner
  • 1206 Views
  • 2 replies
  • 0 Helpful votes

i have switches already configured with snmpv3 and i need to move the configuration to other switches and have some understanding of the commands: 1-does "access snmplist" is an access-list that points to the server which is using the snmp like solar...

baselzind by Frequent Contributor
  • 1288 Views
  • 2 replies
  • 0 Helpful votes

Hello.I'm having an issue with SSH console slowness once connected into a network device on GNS3. It generally slow on any router/switch regardless of the configuration to ssh/vty lines.If using Telnet it's perfectly fine and very responsive but ssh ...

Mantas Sti by Beginner
  • 2010 Views
  • 3 replies
  • 0 Helpful votes

Resolved! APIC-EM

Hello everybody,can any one help me ?!How can i understand that wich version of APIC  is compatible  with my Cisco Prime?For example can any one tell me that version 3.5 and 3.7 of Cisco Prime is compatible with wich version of APIC-EM  ? Best Regard...

R.P7900 by Beginner
  • 1409 Views
  • 2 replies
  • 0 Helpful votes

Hiat first i want to say that am a newbie in networking and i come from germany so my englisch is not the best.So, here is my Problem: I have a Server at home for general purpose and the home lan i share with my family.My router is a Fritzbox 7490 an...

Unbenannt.PNG
Chris35 by Beginner
  • 1256 Views
  • 2 replies
  • 0 Helpful votes

Hi, I have CISCO ISR 2911 and I am trying to setup netflow monitor but right now I have no luck. Here is config I am using: interface GigabitEthernet0/0 ip flow monitor PRTGmonitor inputinterface GigabitEthernet0/0.1 ip flow monitor PRTGmonitor inp...

ivicav007 by Beginner
  • 7337 Views
  • 9 replies
  • 0 Helpful votes