Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Currently I am running this part of a script to export the entire result to our syslog. However I only require 2 parts from the output (highlighted in below output). I have other scripts that do this, but as both lines start with a non consistant cou...

If I run the below command manually clear counters cellular 0 I get the reply Clear "show interface" counters on this interface [confirm] which I need to press return I want to add this command to a script but how do I answer the prompt automaticall...

Occasionally we get the message that logging can’t keep up but within seconds to a minute we get a second message stating it has “caught up”. The Critical message is:Reporting Client: The reporting system is unable to maintain the rate of data being ...

davethomp by Level 1
  • 1614 Views
  • 2 replies
  • 0 Helpful votes

Hi, Could some one please provide asisstance as to what I am doing wrong in setting up the static routing, In the Destination LAN IP:  192.168.2.17 (Other network IP Address)            Subnet Mask:           255.255.255.0            Gateway:       ...

I have an EEM script that generates this output based on monitoring my WAN interface load: %HA_EM-6-LOG: INTERFACE_LOAD: BW: 50000 kbps/sec || TX: 15/255, 1651000 bits/sec, 598 packets/sec || RX: 8/255, 3057000 bits/sec, 627 packets/sec I would lik...