Network Management

Good afternoon gentlemenI need to configure the same as shown below in Nexus 5000 switches. The requirement is logging all user access login (whether failed or succeeded) and also logging all commands that users issue.--------------------------------...

When I try to deploy an IOS using the software deployment in Cisco PI 2.0 the jobs always fail. I have tried many different configurations and even switched flash cards but nothing works. The TFTP/SCP jobs always fail. Doing a "show flash:" I can see...

Is there a MIB entry that will have the supervisor model, if present?  I am trying to generate an inventory report that includes the type of supervisor engine but cannot seem to find an OID that is consistant across different platforms to query for t...

Hi everybody,I made a fresh install of the new version of Cisco MSE 7.6.100 and when I want to access the web interface, I have this message:"Service Temporarily UnavailableThe server is temporarily unable to service your request due to maintenance d...

In Prime LMS 4.2, has anyone seen this issue/bug before?I've added in all devices indicating their Device Names and Hostnames. However in the Monitor section and only High Severity Faults part, the Device Name is actually showing IP addresses.In the ...

Hi, I have a problem with session idle timeout of a "System monitoring" user in Cisco Prime 2.0. I try of disable the  "User Idle Timeout" option from User Preference menu, but the session is closed after 20 min of inactivity regardless of the option...

Hi AllI was trying to do a custom report for SysUpTime.. Report looks good, and is working, but the times shown in the report is different from what we see in "show version"Basically the inventory update (even with a detailed device report) - has a w...

Have a Cat 4507 with Supervisor 7-E, setup configuration to send NetFLow information to an external server, everything worked great but after 2 weeks, the exporter is showing zero packets sent and the following error is at the console:Nov  5 15:52:35...

Im trying to use EEM to check the output of "show interface description | include TEST" to shutdown all ports with the description TEST. Was wondering if anyone had any ideas