Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi,I have been following the steps in this document (Cisco IOS XR Programmability Configuration Guide for ASR 9000 Series Router - Using Data Models [Cisco ASR 9000 Series Aggregation Services Routers] - Cisco)I copied and pasted configuration I push...

jameslee_0-1721277452208.png jameslee_1-1721277512854.png jameslee_2-1721277512856.png
jameslee by Visitor
  • 2385 Views
  • 7 replies
  • 0 Helpful votes

Is it possible to configure EEM to execute an action whenever any one of multiple syslog messages matches a pattern? I would like to know if it is possible to write syslog patterns using an "OR" condition.

CHISHIUNG by Level 3
  • 121 Views
  • 1 replies
  • 0 Helpful votes

We are not using camera and sensors in our environment. Organization->Firmware upgrades->Schedule upgrades-Any status (critical).I am getting all are related to camera and Sensors. I dont wish to see this details in the path Organization->Firmware up...

Annis by Community Member
  • 188 Views
  • 1 replies
  • 1 Helpful votes

Hello,   if you want to use the dohost command in guestshell, you need to have the "ip http server" enabled. however, i want my script to enable this if it is not configured (for security reasons, it is always disabled in our standard config). now, l...

gnijs by Level 8
  • 1413 Views
  • 3 replies
  • 0 Helpful votes
Top Solution Authors