Hi,
Hoping to avoid a reboot or services restart. Does anyone know if you still need to reboot/restart firepower once a custom Application detector is applied? Using version 6.0.1.2
I am deploying ASA5525-X with Firepower IPS using Firesight 750 appliance and I need some basic guidance.
I have defined ACL on the firewall with logging enabled and directling all accepted traffic to IPS sensor.
Now since the ACL's are enabled with ...
I recently configured a new, named interface on my ASA. I then rebooted the ASA and went to FMC to add this new interface to a security zone. I could not get FMC to see the new interface. I ended up having to delete the ASA from FMC and re-add to ...
We have two new 5516 ASA with sourcefire modules. Modules were upgraded to version 6.2.0
We have purchased TAMC licenses. We created and added the licenses to the sourcefire modules through ASDM.
Now we deployed Cisco Firepower Management Center vers...
Community.
I am trying to configure SNMPv3 on my 5545x and have Solarwinds monitor it via SNMPv3 as well. Im running into an issue where eventhough im entering the passwords and encryption/hash methods exactly the same on the NMS (Solarwinds) as I d...
Hello,
My internet connection crawls when I enable my NAT rule 1-5 on the 5506ASA. Picture shows all of the rules.
The Nat Rule that should take care of my internet connection is rule 13.
I also took a screen shot of my Connection rate and Xslate st...
I just got this job a couple of weeks ago and they have older Cisco equipment they want me to work with right now before I let them know of my recommendations for upgrading. We have a WAN link from Cox in San Diego, CA. that provides the internet for...
Hello,
I would like to know How User to IP Mapping works in Cisco Firepower Appliances 9300 and 4100
Below are My Questions:
1. Maximum Number of AD Servers Supported in FTD ?
2. Can we Integrate Existing Syslog with FTD for Identity Based Polic...
I SSH'd into my Firesight MC server and went into shell access to check something.
However, I can't figure out how to get back into the FS IOS now
When I SSH back into the unit, it goes right into the Linux shell
Anyone have the command to get me ...
Hi,
I am working on a report to display date, time, url and browse time for users. Can anyone help with this. I'm using connection events but there are no options in the "field" list to get time the url was accessed and the numbers of minutes/hours s...
Hi,
we have a single ASA 5505 with 256MB RAM (10-Users Base license) and we would like to upgrade to 9.2(4.5). According to the documentation, the upgrade path would be to upgrade first to 8.4.
http://www.cisco.com/c/en/us/td/docs/security/asa/migr...
Hello Community!I would like to clean up an old ASA (5520) which is still in production, so I cannot just wipe the config and start over and I was wondering if there is way to know which object groups are being used and which are not (so I can delete...
Thinking to select a group of important well defined hosts and apply a stricter IPS level. Anyone using the above policies? Moved from balanced security to a stricter policy?
