Can use IPsec on C891? Thanks -------------------------------------------------Device# PID SN-------------------------------------------------*0 C891FJ-K9 FGL183722U0 License Information for 'c800'License Level: advipservices Type: PermanentNext re...
Question on NGIPS can someone please explain how under Transport and Network Layer the "inline normalization" work on NGIPS ?
Cisco ASA send NSEL data . "Netflix Secure Event Logging. Hello I bit confuse how the 3 map are configure are and what they do. can some please tell me if I am correct how ASA is setup to send DATA to NSEL. Policy Map = setup to collect IP addressCla...
Hello, Does anyone know if the ASA strong encryption license for FPR 1K are free and how to order those? Should I create a case with Cisco License and request one to my smart account from there? I have not been using ASA since it was PAK licenses an...
Hi,We are looking at an active active internet feed, which is achieved by using multi HSRP groups, on an ASA do you know if its possible to route traffic out to two different gateways if both gateway IP's are in the same subnet?
Hi All,,We've just enabled ECMP with two 1Gbps AWS direct connect links over the weekend.The ECMP zone is created in the global routing table, we didn't use VRF, and added equal cost static routes destined to AWS networks in the global routing table....
Cisco FTD 4150 unable to send mem usage into our monitoring tool. CPU usage is Okay. Cisco FTD 4145 unable to send mem usage. I am using below OIDs 1.3.6.1.4.1.9.9.48.1.1.1.5. ciscoMemoryPoolUsed 1.3.6.1.4.1.9.9.48.1.1.1.6. ciscoMemoryPoolFr...
Could you help me check oid of cpu and memory as the cli command below ? > show cpu usageCPU utilization for 5 seconds = 8%; 1 minute: 9%; 5 minutes: 9% >> show memoryFree memory: 46568759296 bytes (62%)Used memory: 29531140096 bytes (38%)-----------...
hi,my SNMP mgmt systems does not read interface traffic stats. Everything is on zero. What could be a problem? br
HI All,We have had an incident today that one of the objects are suddenly blacklisted and traffic getting dropped by snort, even though our intrusion policy is not inline and doing IDS. I've looked at global block list in the SI objects, but not list...
Hello,I have a new setup for a client, any insight would be greatly appreciated.Setup will be: ISP1, ISP2 (SD-WAN), New CB Series Router, New FPR-1000.I'm basically looking for the best way to set this up with both ISP Links UP and PBR to send ONLY V...
Hello,Is it possible to configure multiple Netflow destination in FTD managed by an FMC (version 6.2 to 6.4.0.7) ?Thank you for your feedbackBest Regards
Hi, I have taken the backup of FMC by Ssytem -> Toos -> Backup/Restore ->Firepower Management Backup option. Then I have tried to take the backup of FTD by Sytem -> Toos -> Backup/Restore -> Managed Device Backup. But I am getting a note that : Ba...
My customer has a ASA 5525 with version 9.14(4)7 and ASDM 7.18(1)152He created a new VLAN-sub-interface below his port-channel6. So far so good.But when he wants to create rules for this new vlan, the section is missing in the firewall configuration-...
How do we get the Firewall Migration tool to run through a Firewall.What are the Public IP's it needs or the URLs?
