Hi, PFA, I need to add inside network 192.168.1.100-110(10 host) of ASA1 into DMZ(10.20.1.100) of ASA2 for application. is it possible to achieve it using NAT on ASA1 firewall. Please help me to write NAT configuration on firewall.
Hi, PFA, I need to add inside network 192.168.1.100-110(10 host) of ASA1 into DMZ(10.20.1.100) of ASA2 for application. is it possible to achieve it using NAT on ASA1 firewall. Please help me to write NAT configuration on firewall.
is it possible to run a firesight sensor in "simulation" mode ? i.e can it show if a particular access control policy was enforced what would be allowed and what would be blocked ?
We currenlty run our ASA 5555X with the SF module installed. To date we have had no issues with it. I have a requirement to block a specific inbound URL path to our ACE proxies. For example https://www.test.com/api/important I would like to filter vi...
Hello All, Is there no longer installation packages (.tar.gz) for 32-bit (*i386) Linux distributions? We have the AnyConnect Apex licenses, but I do not see any download for 32-bit Linux distros... They all specifically say 64-bit Linux. Thanks, M...
Hi everyone; I want to buy 2 ASA 5512-fwpr-k9 and I want to make them on Active/Standby is that possible ? if yes; should I have 2 licenses (L-ASA5512-TAMC-3Y) one for each or should I have just one between them ? are this model provided with Secur...
Hi Guys, I have setup a syslog alerting on Firesight Virtual Defense Center but i am unable to get the inline result for the events. Below is the sample raw event i received Apr 14 01:09:20 XXXX XXX : [Primary Detection Engine (a9d9147e-dd96-11e2-...
Hi, There is a problem with my ASA and BFD through it. BGP sessions are constantly breaking: *Dec 7 05:47:34.476: %BGP-5-ADJCHANGE: neighbor 192.168.0.2 Up*Dec 7 05:47:34.992: %BGP-5-NBR_RESET: Neighbor 192.168.0.2 reset (BFD adjacency down)*Dec 7 05...
Hi everyone, We have configured Firewall Stateful Interchassis Redundancy in 2 ASR 1004 working as active-active device scenario. In Zone base policy firewall with redundancy group configuration, is it possible to configure traffic flow between diffe...
Hello! Asa 5525-X. When loaded with ASA version 9.5(2)6, I had a problem with high CPU utilization: DATAPATH-0-1814 99.0% 96.8% 86.9%CP Processing 0.3% 0.4% 0.5%tmatch compile thread 0...
hi all, i've configured 2x ASA for active/standby and i think i've messed up the config. was trying to 'force' the standby ASA with the 'no failover active' command on the active ASA. i'm seeing the 'NoFailover' hostname prompt and 'Failover Off' whe...
Hello everyone, Please can you help me about a rule static Nat one to one is not working well. IN the rule I have three services or three ports tcp 3299, 3200 and 3300, this ports are Nating by the IP address P.P.P.P, when I try test the conection ...
Hi All, and thanks for your help. I have 2 ASA5512x setup for Active/Passive failover. Port 0's on each firewall are connected to 1 Catalyst 2960 XR ( at factory default ) Port 1's on each firewall are connected to a separate Catalyst 2960 XR ( at ...
Hi Guys, In Cisco ASA 5505 ASDM, is there a way to see the remaining TTL for DNS entries. With CLI you can use the command #show dns and it displays the remaining TTL. How can I see it with ASDM? (Backgroud: I am using FQDN based ACL and hence would...
Hello, We're replacing a failed ASA5505 with a 5508 and noticing they're not similar right away. The previous ASA had a vlan with 2 subnets configured, then configured the switchports to access members of the vlan. This was ideal for our servers...
Hello,everybody. I have two asa 5555-X . I what to do a failover with active/standby, and I have already done. but I have a problem now, if asa outside interface goes down, I want to asa inside interface goes down, to effect downstram device go to ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-22-2025 05:45 AM | ||
07-16-2025 04:21 AM | ||
07-06-2025 01:40 PM | ||
07-04-2025 01:59 AM | ||
06-19-2025 07:32 AM |
User | Count |
---|---|
8 | |
8 | |
7 | |
1 | |
1 |