Hello All I'm new to the ASA (or firewalls in general) and I'm getting a little stuck with allowing traffic between interfaces. I have two interfaces currently setup and they are used for my inside traffic (connects to a cisco 2611 router) and my wi...
Network Security
Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- Technology and Support
- Security
- Network Security
Options
- Mark all as New
- Mark all as Read
- Float this item to the top
- Subscribe
- Bookmark
- Subscribe to RSS Feed
- Threaded format
- Linear Format
- Sort by Topic Start Date
Labels
-
AAA
(9) -
Access Control Server (ACS)
(6) -
Access List
(4) -
ACI
(10) -
Advanced Threats
(1) -
AMP for Endpoints
(1) -
AnyConnect
(3) -
APIs
(1) -
Appliances
(18) -
ASA
(1) -
ASR 1000 Series
(1) -
Branch Router
(2) -
Buying Recommendation
(84) -
Catalyst 2000
(1) -
Catalyst 3000
(2) -
Catalyst 4000
(1) -
Catalyst 6000
(1) -
Catalyst 8000
(1) -
Catalyst 9000
(2) -
Catalyst Switch
(2) -
Catalyst Wireless Controllers
(1) -
Cisco
(1) -
Cisco Adaptive Security Appliance (ASA)
(9,512) -
Cisco Bugs
(31) -
Cisco Cafe
(25) -
Cisco CLI Analyzer
(1) -
Cisco Cloud Services Router
(1) -
Cisco Defense Orchestrator (CDO)
(139) -
Cisco Firepower Device Manager (FDM)
(812) -
Cisco Firepower Management Center (FMC)
(2,909) -
Cisco Firepower Threat Defense (FTD)
(3,165) -
Cisco Press Cafe
(1) -
Cisco Secure Firewall Management Center (FMC)
(1) -
Cisco Secure Firewall Threat Defense (FTD)
(1) -
Cisco Security Manager (CSM)
(3) -
Cisco Software
(18) -
CISCO START ANZ
(1) -
Cisco Threat Response
(1) -
Cisco Vulnerability Management
(42) -
Cloud
(1) -
Cloud Security
(3) -
Community Bug or Issue
(1) -
Community Feedback Forum
(31) -
Community Ideas
(18) -
Compliance and Posture
(1) -
Crypto
(1) -
CSC Content with No Valid Community to Post
(1) -
CUBE
(1) -
CUCM
(1) -
Data Center Networking
(1) -
Device Admin
(13) -
EEM Scripting
(1) -
Emergency Responder
(1) -
Endpoint Security
(6) -
Enterprise Agreement
(1) -
Event Analysis
(258) -
FirePOWER
(1) -
Firepower Chassis Manager (FCM)
(2) -
Firepower Device Manager (FDM)
(16) -
Firepower Management Center (FMC)
(408) -
Firepower Threat Defense (FTD)
(221) -
Firewall Migration Tool (FMT)
(25) -
Firewalls
(1,171) -
FMC
(1) -
General
(2) -
Guest
(1) -
Identity Services Engine (ISE)
(9) -
IE3300
(1) -
Integrated Security
(8) -
Integrated Security Architecture
(1) -
Integrations
(3) -
Investigation
(2) -
iOS
(1) -
IPS and IDS
(6,567) -
IPS and IDS1
(1) -
IPS-IDS
(1) -
IPSEC
(1) -
ISE
(1) -
LAN Switching
(7) -
License
(318) -
MPLS
(1) -
Multicloud Defense
(2) -
Network Management
(91) -
Network Security
(2) -
Networking
(1) -
NFVIS
(1) -
NGFW Firewalls
(37,553) -
NGIPS
(1,872) -
Online Tools and Resources
(1) -
Open Source and Open Standards
(1) -
Optical Networking
(3) -
Optics
(1) -
Other Automation Analytics Topics
(1) -
Other Collaboration Topics
(1) -
Other Community Feedback
(5) -
Other Firewalls
(1) -
Other IP Telephony
(1) -
Other NAC
(18) -
Other Network
(1) -
Other Network Security Topics
(10,769) -
Other Networking
(8) -
Other Routers
(9) -
Other Routing
(24) -
Other Routing and Switching topics
(2) -
Other Security
(1) -
Other Security Topics
(18) -
Other Switches
(11) -
Other Switching
(4) -
Other VPN Topics
(1) -
Passive Identity
(1) -
Physical Security
(20) -
Policy and Access
(2) -
Prioritization
(2) -
Remote Access
(2) -
Room Endpoints
(1) -
Routing Protocols
(7) -
SD-WAN Security
(1) -
Secure Network Analytics
(1) -
Security
(3) -
Security Management
(624) -
Segmentation
(3) -
Service Providers
(1) -
Small Business Routers
(4) -
Small Business Security
(2) -
Sourcefire
(2) -
Support
(2) -
Threat Containment
(6) -
Threat Defense
(1) -
Unified Computing System (UCS)
(1) -
Voice Gateways
(1) -
VPN
(25) -
VPN and AnyConnect
(1) -
Vulnerability Management
(41) -
WAN
(7) -
Web Security
(5) -
Webex Teams
(1) -
Wired
(3) -
Wireless Security
(1)
- « Previous
- Next »
Forum Posts
Dear Support, I am having the ASA 5515 and in this ASA CX module install for contain filtering.I have configure the some policy in CX module through PRSM GUI.I also enable ssh for CX module. My CX module is not have any problem all my policies are wo...
version 8.2(5) is presently installed and running fairly well, however, we need to upgrade the code on the firewall to bring it up to spec. when trying to following the upgrade path to 8.4(6) the following errors occur after the reload. Please advise...
Recieved an RMA FWSM and cant console to it. Cisco shipped with OS version 2.3 so cant session into it. Console hangs during bootup. The old FWSM being replaced is hardware verison 3.0 and the new is 4.5.Is there a a requirement for hardware version...
I have having serious issues with performance on my ASA 5505s that I am testing with 9.2.3 code.I stripped the config and removed as much stuff as I could - no VPN etc. and I am ONLY getting about 30-40Mbps downloads from sites but 95Mbps uploads????...
Hi All,Today I completed an upgrade of an Active/ Active ASA set-up based on 5585-X hardware. The original software version was 9.1(4), the newly installed version is 9.2(3).Since reloading with the new version alerts (severity 1) related to SCPS are...
Hello friendsI am getting a strange behavior in CSM version 4.4. I have successfully added a Router to the Device Inventory, and then when I try to add it to a Policy Bundle that I had already created, I am getting an error message at the time I try ...
Resolved! SNMP Traps 1.3.6.1.4.1.9.9.41.2.0.1
Hi Experts,I wanted to know what is this Trap mean " 1.3.6.1.4.1.9.9.41.2.0.1". which has received from our firewall to monitoring device. From where we can check? Regards,Ashish Ojha
Hi all, I have a Pix 515e version 6.1(5) I need to let PPTP pass through, is there any special configuration I have to do? I have already enabled the pptp on the ACLs. Thanks.
Hello, I have a network object group that contains individual objects and additional object groups. Is there a way to export this showing the IP address, netmask and description? I don't really mind having to export more than what I'm specifically lo...
Resolved! IOS hash check
I am attempting to check my organization's IOS hashes. I have some that have been saved on a word document, but I do not trust that these are the latest. Can anyone point me in the right direction? where can I verify these values?
Have a cisco ASA running ASA V 8.3Wondering what the correct syntax is or even if it is possible to create a network object from a list of IP's in CIDR format? Typically just do this:Create network-objectobject-group network namenetwork-object 1.2.3....
My internet was set up by Hughes Net. I have a guest connection BUT HAVE NEVER KNOWN the GUEST PASSWORD. How do I find this out so my guests are not using my work related internet? It's been a year!
Hi Friends,I am using an ASA 5520 (Software Version 7.0(8)) and having a challenge with routing. I have 3 interfaces - Trust, Untrust and Untrust-1 with Security levels set to 100, 0 and 25 respectively. Trust is our LAN network, Untrust is connecte...
Hi all,I have been supplied this link from our Cisco account manager that explains how to trial Cisco Firepower.https://communities.cisco.com/docs/DOC-55301 However the doc seems to be incorrect, and I can't find the firepower download anywhere in th...
Learn, share, save
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Unanswered Topics
| Subject | Author | Posted |
|---|---|---|
| 07-16-2025 04:21 AM | ||
| 07-06-2025 01:40 PM | ||
| 07-04-2025 01:59 AM | ||
| 06-19-2025 07:32 AM | ||
| 06-17-2025 01:07 PM |
New solutions
Top Solution Authors
| User | Count |
|---|---|
| 10 | |
| 7 | |
| 5 | |
| 2 | |
| 1 |
