Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi all, I have an asa 8.2 with 2 interface inside and outisde.Ip source 192.168.50.5Ip destination 192.168.100.125Port 25When I do a packt trace.packet-tracer input inside tcp 192.168.100.125 smtp 192.168.50.5 smtp !Phase: 1Type: FLOW-LOOKUPSubtype: ...

I am currently looking for a way to exlude IP's from the Malware File lookup on a perimeter 3D sensor but am not having much luck. For example, there are Windows patches and other trusted file deployment events that go through the sensor to multiple ...

mvollersf by Level 1
  • 1816 Views
  • 2 replies
  • 0 Helpful votes

Hi all, I have a 5512-X. It was not initially ordered with the CX module.I was led to believe that the 5512 and 5515 models can now install the CX module in software and don't need the SSD drive?The reason I believe this is to be the case is that I h...

sossie by Level 1
  • 1068 Views
  • 4 replies
  • 0 Helpful votes

Hi, i have problem configuring DMZ to access outside.I'm not able to ping from DMZ network to DMZ interface (gateway) neither am i able to contact the internet with DMZ hostsI'm able to ping from LAN to LAN gateway (inspect ICMP service policy) inter...

hi,i created a S2S VPN and the ASA2's internet connection isn't that good and some packet losses would be 'normal'.i'm not sure if that relates to the unequal encap/decaps on my 'sh crypto ipsec sa' output.is the below reading normal? ASA1:      #pkt...

I am doing some testing of access and identity policies and need to make sure that when I run a test of changes to the policies that I am seeing accurate results vs. getting inaccurate results due to the ASA still using active flow or cached settings...

tato386 by Level 6
  • 1048 Views
  • 4 replies
  • 0 Helpful votes

hi all,apologies for my NAT getting rusty, just a quick confirmation if my identity NAT below is correct: object network IDENTITY-NAT-OBJ  host 111.203.23.1object network INSIDE-NET-OBJ  host 111.203.23.1  nat (inside,outside) static IDENTITY-NAT-OBJ...

So i understand the basic syntax for NATing a single internal network to an outside interface for allowing internet access.  Something like below... object network NAT_INSIDE_NETS  subnet 10.0.0.0 255.255.255.0object network NAT_INSIDE_NETS  nat (ins...

Review Cisco Networking for a $25 gift card