Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Issue with IDM access to IPS module To anyone that can assist! I have a situation where I can only connect to via IPS module using the ASA console and opening a session to the module itself. I cannot open an IDM session at all. This device is acting ...

Can anyone let me know how to configure Load balancing between two cisco ASA and share me some configuration example with network diagram. Also let me know how to achieve load balancing in ASA in Active-Active failover set up.

Greetings,I have like 600 concurrent users and I would like have a best firewall solution where i can block unnecessary websites for them. Also to block HTTPS websites. ThanksJunaid Zeb

jzeb by Community Member
  • 769 Views
  • 4 replies
  • 0 Helpful votes

HiI have ASA 5520 WITH 2 DDR RAM 256, total 512MB, and i can't access by console and when power on show mePOWER: green,STATUS: amberACTIVE: orangeVPN : greenFLASH: offAnyone faced this issue before?Thank you 

Toss Leey by Level 4
  • 852 Views
  • 4 replies
  • 0 Helpful votes

Resolved! ASA ACL question

I am new to the ASA and am trying to figure something out with ACL's. I understand about creating them and adding in entries and that they all must have the same name, but I am confused about ACL's that do not have the same name that already exist on...

Jon Moots by Level 2
  • 1029 Views
  • 3 replies
  • 0 Helpful votes

Is there a standard (best practices) way of naming objects, object-groups, services objects and service object-groups in ASA firewalls? For example:If you had IP addresses that pertain to a particular set of application servers that included 10.1.1.1...

Mike Keenan by Community Member
  • 7844 Views
  • 1 replies
  • 0 Helpful votes