Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi All,     I recently replaced a series of ASA 5505's with a singular ASA5515X firewall. All seems to have gone well but one group of users are reporting a problem with VOIP. They are the only VOIP users on this firewall.     They have Cisco VOIP ph...

I need to accomplish the following for Citrix Session Reliability, but will I do the configuration, I get a warning. I'm not sure I'm setting this up correctly. object network citrix-session host 172.26.144.16 nat (inside,outside) static citrix-exter...

Hello I have (4) new ASA5545x' I also received (2) sets of the following licenses which came CD in white cardboard envelopes:          -Cisco ASA 55xx Series         Any Connnect Mobile         ASA 5545 License         Product: ASA-AC-M-5545=        ...

Hi all,I would like to know if the SSP module have all the IPS features.I could see in the IPS datasheet some features that are not mentionned in SSP datasheet (listed below).Protocol Anomaly DetectionEvasion Identification and MitigationApplication ...

Hi all.  I am trying to open port 1194(openvpn) and forward it to the server I have on the inside.  I've followed several different sites that had both ASDM or CLI instructions but to no avail.  Would someone be able to suggest what I need to add?  I...

backpage1 by • Community Member
  • 4127 Views
  • 2 replies
  • 0 Helpful votes

Hi there. I just trying to do PAT with gns3. but not working and i don't have any idea. (Cisco Adaptive Security Appliance Software Version 8.4(2))and also i figure out that there are some changes in nat configuration. i did but didn't work. I cannot...

CATYO by • Level 3
  • 1398 Views
  • 6 replies
  • 0 Helpful votes

I have two Cisco ASA5540X firewalls with IPS modules configured in a failover pair. Behind this firewall pair (on the inside) are about 140 hosts that use various web-enabled applications, minimal Internet, some email (maybe 10 hosts), and some light...

Hi, Question 1:From which signature in reconnaissance can detect scanning such as nmap or qualys.?I performed scan but none is detected. I think it is not just enabled. Question 2:I may allow scanning from time to time but with source address defined...

Hi All ,I have an issue with static NAT on ASA 5520 Version 9.1(2) firewall.Configuration as below interface GigabitEthernet0/0 description outside nameif OUTSIDE security-level 0 ip address 10.x.x.x 255.255.255.0!interface GigabitEthernet0/2 descrip...

msameerkn by • Frequent Visitor
  • 3045 Views
  • 8 replies
  • 0 Helpful votes

 Hi Everyone,I am using two public IP for my home network via Bridged ModemSetupRouter Switch ModemASA Switch ModemBoth Router and ASA have public IPs and are on separate network.Outside interface of ASA has no ACL to permit any traffic on port 443. ...

mahesh18 by • Level 7
  • 2926 Views
  • 9 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card