We have five public ip addresses from Comcast. Right now they are being used by one firewall and four routers (one public ip per device). Is it possible to have a single ASA5500-x to utilize all five public ips? For example, have the outside interfac...
Hello everyoneI'm installing a new site-to-site VPN connection between two sites, having problems bringing the tunnel online.We have two ASA 5505 firewalls - one at our Central site, and another for our customer at the Remote site.I wiped both firewa...
Hi Guys, need your help. I have a newly purchased Cisco5510 and I am configuring it as usual from the other high end ASA. But from this ASA, I cannot create a subinterface and cannot configure nameif from the main interface. Is it really a behaviour ...
Guys we have an ASA 5505 which is running 8.2 code we have three vlans 1, 2, 3 vlan 1 is insidevlan 3 is connected to another office vlan is 172.168.1.1 (same owners) and we have few servers there which are 192.168.1.0/24 (server farm) vlan 1 is 10....
My ISP (Zen) has given me a block of 8 ip's but i need to connect via PPPoE. The ASA 5505 only allows me to put the static in as a /32 instead of a /29.Has anybody configured an ASA with a block of 8 ip's using PPPoE before? regards,louis
Hi,We connect to ASA 5510 using PUTTY ssh connection. From ASA privilege mode we take access of IPS sensor module using session 1.We logged all session outputs on PUTTY to file and gave #show tech on sensor prompt.After a while PUTTY hangs and displ...
I need to connect 1 interface to mpls not nat-ed (Vlan2) and 1 connection to internet nat-ed (Vlan3). So all traffic out vlan 3 except for private network over mpls. ASA Version 9.0(3)!hostname X.X.X.Xdomain-name X.X.X.Xenable password XXXXXXXX encr...
I have an interesting question. We are going to try and run equal-cost multi-pathing through a transparent firewall. There will be two routers on one side and two on the other running eigrp between them. The question is, if a packet leaves one por...
I have a intermittence problem with my ASA 5540. When testing connectivity to the servers directly connected me respond randomly.I have reviewed the ARP tables, finding no problems. I did a debug ARP and I throw the following errors: arp-req: request...
Hi I would like to know whether we can configure Same Vlan and assign to multiple physical ports in Cisco ASA 5525X series firewalls. The interfaces are connected to same subnet. These are directly connected to servers in DMZ and no switches in betwe...
Hello,I have a ASA 5520 and will need to create a trunk to a 3750 from the one of the ASA's gigabit ports, this will allow me to create sub-interfaces on the ASA and use multiple VLAN's on the switch. For the trunk do I need to use a crossover or st...
How do I locate the preshared key on an ASA firewall. Specifically, how do I find out what ***** is in the below configuration within my config file on my ASA firewall running 8.4(4)1?aaa-server xxxxxxx (MGMT) host xxx.xxx.xxx.xxxtimeout 30key *****
So, is there a solution for having multicast enable and also have ASA in multiple context mode?
Hello, How do I get the real-time log viewer to work in the ASDM? It just shows nothing, but my home ASA 5505 is showing information and I haven't configured anything on that one.We have a 5520 on 9.1(3), ASDM 7.2(1). Thanks
In our computer room we have an ASA 5520 firewall. At some point we have decided to change this firewalll with new ASA 5515-X and we copyed the exact configuration of the old asa 5520 to 5515-X. A problem was occured after the migration between ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 08-25-2026 06:22 PM | ||
| 08-24-2026 12:26 AM | ||
| 08-20-2026 05:54 AM | ||
| 08-19-2026 07:59 AM | ||
| 08-10-2026 08:58 AM |
| User | Count |
|---|---|
| 4 | |
| 1 | |
| 1 | |
| 1 | |
| 1 |
