Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Please forgive me in advance for being such an idiot, but for the life of me, I can't figure out why my second network cannot access the ASA or anything outside of it. If my outside interface is 55.242.141.20, and my internal is 192.168.1.0, everythi...

Resolved! implementing pat

I have a little bit of confusion on implementing global address pools and PAT.  I want to do a many to one translation.  I have a FWSM that has a /24 network bound to an interface for guest wireless.  All I want to do is use private IP addressess and...

jlhainy by Level 2
  • 911 Views
  • 7 replies
  • 0 Helpful votes

Looking at the changes in NAT syntax after the upgrade.... how would I do the following in 8.3+?1)access-list Encrypt extended permit ip 172.10.35.0 255.255.255.0 172.10.18.0 255.255.255.0 access-list Encrypt extended permit ip 172.10.36.0 255.255.25...

aelsbernd by Level 1
  • 1038 Views
  • 1 replies
  • 0 Helpful votes

Hello all,I understand that in transparent mode an ASA5510 would only be able to have two interfaces, inside and outside.My question is could one of those logical interfaces be an LACP'd interface, made up of two physical interfaces. Topology below.I...

Good Morning All,I am confiuging a DMZ on my ASA 5510 but I have run out of physical ports, since I have dual Wan ports configured.  I plan to implement a DMZ using subinterfaces.  I have 2 questions:1) Do I need to configure a Vlan to complete this ...

I have cisco pix 520 Firewall and I forgot my firewall password but now I want to reset so I have to get into monitor mode but when I press escape key my firewall is not get into monitor mode. so now how can I get into monitor mode or Are there any O...

Resolved! ASA Implicit Deny

HiIm new to the ASA firewall. With no ACL's configured Im trying to ping from a host in the inside to a host on the outside. Pinging from  a level 100 to a level 0. This is permitted and I realize that I would have to create an ACL to permit icmp pin...

Has anyone experienced this I was enabling all the ports for testing on an asa 5510 and once I got to port e0/3 I got this error:ciscoasa(config-if)# int e0/0ciscoasa(config-if)# no shutciscoasa(config-if)# int e0/1ciscoasa(config-if)# no shutciscoas...

sam saeed by Level 1
  • 1499 Views
  • 4 replies
  • 0 Helpful votes

Hi All,Hope you are doing good. I am currently trying to configure PAT on our FWSM. There are a large number of hosts(four private /24 subnets) that need to be patted and they are ending up using all the ports that can be PATted via one ip address. T...

So here is my situation, let's start with the networkI'm working on a cisco ASA 5510, not sure of the OS, but its the pre-8.3 NAT10.0.100.0/24 -> inside network (inside VLAN)192.168.100.0/24 -> What i need to NAT to (several ranges via another device...