Network Security

Hello,I am trying to allow access to a mail server using cisco asa 5510. Unfortunately, the static translation does not work as show nat gives the following output:translate_hits = 0, untranslate_hits = 223config extract is shown below:

Hi,I have PIX 535 and using ACLs for allowing traffic. I need to clean up the rule base. I would like to know how to fetch a report of Unused rules for long time?Also when a traffic is being allowed, I want to know through which rule number its being...

Hi,Is it possible to configure only one context in H.A. in FWSM? , yesterday  I tried to configure this but I can´t .Please check my configuration and tell me your opinon, or not is possible ,  maybe I have to configure all context in H.A.This messag...

Hi,I have two ASA5510-BUN-K9 Fws and I am planning to buy 2 x L-ASA5510-SEC-PL= to put them in HA.I was wondering if the support contract that I curently have for the two ASAs is still valid or do I have to buy any support upgrade?Any help is much ap...

I am a beginner to ASA. I am trying to connect the ASA 5505 behind the netgear ADSL router which is getting dynamic IP address from the ISP. How to configure the ASA5505 outside interface for SSL VPN connectivity?Could anyone help me on this? Your he...

I am really new at this, so please forgive my ignorace. I've configured, to the best of my ability, a tunnel between my asa5505 and a firebox X using this guide, I had to feel my way through it since the ASDM in the guide is an older version:http://w...

the story is we configure the monitor interface  insidemonitor interface  outsidemonitor interface  partnerand save configuebut when i show run monitor-interfacethe configure do not show the 3 montitor interfaces, it only show other monitor interface...

I have 2 ASA5520's in failover pair.After failing over I cannot run ADSM on the secondary (now active device), I get "unable to launch device manager from [primary address]"I can ASDM to the primary device (now marked as "standby ready") on the failo...

On a Cisco ASA 5520.  I have 2 interfaces that are the same security level. I need hosts on 1 of these interfaces to be able to get to a specific IP and port on the other but I DON'T want to blanket enable 'same-security-traffic permit inter-interfac...

Dear All,I have a ASA5508 running in 8.3(2) and without enable NAT. If I do a static network address translation for a inside address. any Implict rule in xlate?In another words, what is the forwarding rule ASA choose while there is routing exist and...

Hi experts,My company uses a pair of 5510 ASAs as the gateway to Internet. I once configured policy-map to filter certain webpages (facebook, twitter, ...etc) and they work fine. However nowdays those websites all support HTTPS. In the https the URL ...