Hi, Just wondering if anyone else has seen this behaviour ....When I use ASDM or the CLI to copy (ftp) files from my management station to flash on my ASA5520 I get to 99% and then the gui or cli window hangs.The ASA itself completely free...
Hi, Just wondering if anyone else has seen this behaviour ....When I use ASDM or the CLI to copy (ftp) files from my management station to flash on my ASA5520 I get to 99% and then the gui or cli window hangs.The ASA itself completely free...
Hi all, we have two environments, one test and one production, each with two Cisco IPS 4260 sensors equipped. We use for the administration of the sensors Cisco IME 7.0.3. The sensors are running with IPS engine 7.0(5a)E4. Now we tested the Cisco IPS...
I have a ASA 5520, and im trying to set up a Mitel Border Gateway. If have successfully nat'd an outside address to the its IP on the dmz that allows traffic in from outside, however I cannot get the proper translation/ACL working for it to also be ...
I was wondering if the ASA 5505 is sufficient for the CCNP Security track? I am looking into creating a home lab to prepare for the exams.If not which ASA model should I go with? Thanks.
Greetings.A pix 515E with software 8.0(4)28 connects the inside and outside networks. There are some servers in "outside" that have addresses overlapping with the internal subnets (192.168.10.25 and 192.168.10.26), and those servers have a reverse ro...
Hello -I am trying to open up ping through my ASA. The ASA is connected via L3 link on the inside interface to a L3 switch. Same thing on the outsideinterface. I am trying to ping switch to switch via the ASA. I created the ACLs as followsacce...
Hi there,I have a question on Nat. All my inside hosts currently are natted to the pix outside interface. Now I would like to nat two inside ip addresses to one different global address. How should I configure this.Tks
Hi,We want to use an ASA as a pure routing device.Our network has several internal subnets (10.1.x.0/24), and we want to be able to reach them from outside and to allow access between them.We have a defined a VLAN for each subnet range with the same ...
We currently have a Gig-E fiber SMFC that comes into our data center. The SMFC comes already into a SFP in a switch that converts it to Gig-E Ethernet. I am looking at Cisco as a possible firewall and IPS solution to replace our existing hardware a...
Hi,looking to setup Multihoming between a DSL (Dynamic) and a T1 (Static). When first attemted this it worked for websites but streamin video (youtube.com) did not work.Does anyone have any suggestions.
First off, let me preface this by saying that I'm a novice when it comes to firewalls and more specifically, the ASA. I do however, have an above average understanding of switches/routers.We have an ASA 5510 running 8.3 and recently I've decided to ...
Hello,I have installed an SSM module in a 5510 firewall, and am running IPS in promiscous mode. Using the default configuration i can see lots of packets being denied, and when i tested it in inline mode almost all the websites i tried to connect to...
Hi Guys,I have recently started investigating IPS for deploying to our clients, however for one of our clients we deployed to a simple routine reload killed the router...I managed to go onsite and get it working, however I noticed that when "ip ips i...
Hi , please go through the topology attached herewith, I have configured ASA in transparent mode.At present all traffic is allow vice-versa.My purpose is to deny traffic for the following Ip address.source 172.16.1.0 destination 172.16.99.0 actio...
I have a similiar situation to this here (https://supportforums.cisco.com/thread/2064372?referring_site=kapi&channel=smartnav) What I have is 3 interfaces on my PIX.- Outside: 216.116.87.0/24 (security level 0)- 469: 172.16.6.0 /24 (security level 10...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 12-31-2025 01:53 AM | ||
| 12-15-2025 09:32 PM | ||
| 12-11-2025 07:27 AM | ||
| 11-13-2025 12:52 PM | ||
| 11-03-2025 09:48 AM |
| User | Count |
|---|---|
| 4 | |
| 3 | |
| 2 | |
| 2 | |
| 1 |