Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I recently started working for a new company and am learning their environment.  They have an HA pair of ASA 5580-20's running 8.3(2) code.  I have worked quite a bit with ASA's in the past, mostly running 7.2(4) and 8.2 trains.  I was surprised when...

rdessert by Level 1
  • 2015 Views
  • 4 replies
  • 0 Helpful votes

Dear boss I  have another asa 5520 and it is configured. when i do factory default  every thing  erase. ok. when i enter again it promped for enable  password. and it takes my privious password taht i gave in full  configuration.It generally comes no...

Dear bossI have a ASA 5520  with IPS in my Data center. i am using it for routing and access list.  it is running and my all 80 branches running on it.now i want to enable IPS.How i start it ?when i click on IPS on graphic mood an it asking an IP. wh...

Dear all,I will be honest and admit that I've gained my knowledge of ASA-5520 through trial & error and practical experience and I have no previous proper education on the matter, and I configure the ASA mereley using the ASDM (I have little knowledg...

HelloInside Network - 192.168.100.0DMZ Network  - 192.168.200.0static (inside,dmz) 192.168.100.1  access-list inside-dmz-static-nataccess-list inside_dmz_static_nat extended permit ip host 192.168.100.1 any This actually works. But my question is isn...

Hello all,I have one problem with PIX high CPU loading %85 (PIX Version is 8.0(3)). please see the below log:pixfirewall# show cpu CPU utilization for 5 seconds = 86%; 1 minute: 86%; 5 minutes: 86%pixfirewall# show processes     PC       SP       STA...

We recently upgraded our ASA to 8.3, most everything went ok, but I am having problems with outgoing nat. It seems that when one our systems that needs to be natted to an outside IP address when connecting out is not doing it. When that system goes o...

There is a PIX firewall and it has this configured on it.static (inside,outside) tcp interface 3389 192.168.1.250 3389 netmask 255.255.255.255 0 0 This line of code works ok for port 3389 but I want all tcp ports to be translated.  Not just 3389.  Ho...

mdargin by Level 1
  • 674 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card