Buy or Renew
Buy or Renew
NEW! Stay up-to-date on Cisco Secure Access: Software Release Notes and Announcements

Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Free

 
Labels

Forum Posts

Start a conversation

Resolved! Cisco VPN Client and 64 Bit OS Support

I am in the planning/testing stages of migrating users to the Cisco VPN client. Problem I have come across though is I can't find a version that supports 64 bit operating systems. I have looked through the download center with no luck. Am I just over...

venom43212 by • Level 4
  • 161653 Views
  • 7 replies
  • 0 Helpful votes

Reg. Active-Active failover

hi halijenn / experts1) A firewall is configured in active-standby mode and i want to configure the same in active-active failover .Hence wanted to know if we can restore the configs present in the active -standby mode (which will get lost due to the...

Resolved! Upgraded ASA 5520 memory for 8.3(1), now ASA reports high memory utilization

I upgraded our 5520 to 8.3(1) last week and also upgraded the memory. If I do a "show memory" on the ASA, it reports the following:lsfw01# sho memory Free memory:      2313296496 bytes (108%)Used memory:      4129154448 bytes (192%)-------------     ...

troymaki by • Level 1
  • 763 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Basic configuration IDSM-2

Hello,I have some experience with sensors but this is my first time configuring a C6500 with IDSM-2, and I have some design questions. The first question is this: can I mix the use of VACL and SPAN to capture traffic in the same configuration?Custome...

identity static NAT and PAT

access-list IDENT-STATIC extended permit ip object-group X object-group Yglobal (outside) 9 x.x.x.xnat (inside) 9 x.x.x.x 255.255.255.0 dnsstatic (inside,outside) x.x.x.0  access-list IDENT-STATICI have the following configuration above which works f...

esossamon by • Level 1
  • 630 Views
  • 6 replies
  • 0 Helpful votes

ASA 5520 Active/Standby Topology Help

I need suggestions on how to design an ASA 5520 Active/Standby solution. Current configuration:T1 coming in from ISP to patch panel (Disaster Recovery site that also hosts our webservers)T1 -> ASA -> L3 Switches -> ServersProposed configuration:T1 co...

jlg by • Level 1
  • 3829 Views
  • 5 replies
  • 0 Helpful votes

Resolved! Zone based Firewall --DMZ

Hi all,I am very new to Cisco, and routing/ firewalls in general.I brought my self a Cisco 1812. Its connected via Fe/0 to an ADSL modem in pure bridge mode. So the 1812 is doing all the PPP auth.I've been following this guide Zone-Based Policy Firew...

View All
Review Cisco Networking for a $25 gift card