Network Security

I have two sites and connected with MPLS links of 2MB with Cisco 2821 routers. Now a requirement came that two sites will have additional server ( one each location - for data replication purpose) and 75% of the bandwidth needs to be allocated to dat...

how can implement nac in non dhcp environment (all users have static ip) ?i need to use virtual GW mode?all the useres must be in the same access vlan ?

In certificate management link --> SSL certificate , here i want to change my signing algorithum from MD5 to SHA algorthiium along with RSA . how we change the signing alogorithum . highly help needed

I'm considering using an existing PIX-515E as one end of a site to site VPN, but can't find any stats for how many Mbps of throughput the unit with no VAC or VAC+ card will handle.Would it handle up to 10Mbps of 256 bit AES IPSEC VPN traffic?

3002 running 4.7 in network extension mode, pix running 6.3(5). Require connections from the private subnets behind the pix to private subnetsbehind the 3002. It appears the 3002 only supports the directly connected subnet off it's private interface ...

Here is my situation:I have a pix 515E currently running with private IPs on both the outside and inside interfaces. I now have to have the outside interface pingable from the Internet and cannot figure out how to do it.This is what I thought I neede...

I'm setting up DAP rules for AnyConnect clients. When I set the default policy to terminate, I get the right results from AnyConnect connections, but all IPSec clients cannont connect. I know I need to set up a DAP rule for IPSec clients to allow the...

Hi all, I goofed on the ASA password recovery (http://www.ciscosystems.ch/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1058131)Now when I boot the ASA the firewall boots into rommon0If I type boot it will load the default config, ...

or even the edge router?

Hello,How can I allow remote access via telnet and SSH to our Cisco Pix 515e? The remote comapny is giving me their external IP they will be coming from too, so we can lock it down to that IP.Thanks

Hi Champs,I have configured timestamp logging on PIX 506E version 6.3(5). However the output of the log message does not give the timestamp. Let me know if i am missing out of anything. Thanks in advance.show logSyslog logging: enabled Facility: 20 T...

Hi,who can help me to understand how work sla monitor IpIcmpEcho parameters?I have a problem with a Dual ISP configuration: the main one is connected to a DSL router while the backup router is an ISDN one.I configured sla monitor in the way of cisco ...