Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hey All,Scenario:I have a cisco 851 that is connection to an ASA box. I don't have access to the ASA (outsourced company) but the 851 is local. They initially wanted to run private Ip's on the switching side but we told them thats not the standard fo...

Dear All,I know that the asr-group command permit to a couple of interfaces (belonging to the same group) to re-route a return packet for a connection thatoriginated through its peer unit.But the asr works also for the new connections?If a new connec...

ifabrizio by Level 3
  • 469 Views
  • 1 replies
  • 0 Helpful votes

Hi!How can I check file names of IOS and asdm loaded to FWSM? If I load new version of IOS, how can I erase the old one? Is it rewrited automaticly?Command "dir flash" shows only that they presented on the flash.dir flash:Directory of flash:/2 -...

Hi Guys, I have pix firewall 525 with software V 6.3. In that pix firewall, i can able to access the one of the dmz server using both nated ip( let say 10.80.80.2) and the original DMZ IP (let say 172.80.1.2). Recently i tried to upgrade to ...

Hi,When we connect to SSL Anyconnect vpn, the ip address assigned seems to be with a gateway next to the ip address being assigned & with the subnet mask as whatever subnet the range belongs to.Like, if i assign pool of 192.168.100.1-192.168.100.14(/...

suthomas1 by Level 6
  • 1804 Views
  • 1 replies
  • 0 Helpful votes

Hi All, I have SSM 10 with ASA 5510. in ASA, I've configured NTP server and it shows correct time. In IPS, I didn't configure NTP server because I assume it gets the time from ASA, and there is no summer time enable in SSM. But it shows one hour off ...

I am contemplating deploying two ISR routers as zone based firewalls. They would have possibly up to four zones on them. I have both 2811s and 3845s and would prefer to use the 2811s as the 3845s have already been ear marked. Does anyone know what ty...

We have two ASA 5510 firewalls with a tunnel between two sites. The tunnel works without issue until one of the sites experiences a brief outage due to the service provider. The VPN tunnel is not automatically establishing after the outage. It takes ...

ctcahoe by Level 1
  • 675 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card