Network Security

Does anyone know if the ASA can redirect to a Proxy Server? For example I want to redirect all web traffic (80,443) to my proxy server.Thanks in advance

if i create two context then its working individual ok but i give two IP address on one interface for different context .How its working individually ?

Hii am using PIX 506E with software ver 4.3.i try to recover my password its fails.Please go through the following .this steps followed during password resetmonitor>interface 10: i8255X @ PCI(bus:0 dev:13 irq:10)1: i8255X @ PCI(bus:0 dev:14 irq:7 ) U...

Hi everyone,I am looking for some clarification on the behavior of an ASA Active/Standby failover pair when the units contain AIP modules. My experience with SSMs is mostly with the CSC module.The documentation states that if the AIP module in the Ac...

New install:5505 VPN with MS Active Directory services on LAN.I can VPN into the network but cannot e.g. join my laptop to the Domain. Message says "cannot find "domain" I can: ping the PDC, RDP onto the PDC or any system on the LAN. Also application...

When i try to see the updates status on IME dashborad i don't see if automatic updates work fine .Only CLI (show conf) show the correct status .Can someone tell me if it's correct o there is another way to see this update status on IME ?

We have configured SSL VPN through SDM on 2811 router, but following error has occurred. Please see attached error message and router configuration for details. Please help at earliestRegards,MS

VPN tunnel working fine, we can access machines on the remote network, connect via rdp but cannot ping.We want to be able to ping from the 192.168.2.. network to the 192.168.1.. networkCurrent config attachedAny assistance would be greatly appreciat...

Hi,How do I backup an IPS config (ASA-SSM-10)?Thanks

Reposting in a new thread since the old one seems to have died...I'm migrating from a PIX 515 to an ASA 5520. The config was created using the PIX to ASA migration tool. The ASDM Packet Tracer shows outbound traffic failing due to NAT.Confignat (in...

I just discovered something that I don't believe should work but it does. I always thought if you were going from a lower to higher security that you required static entries and access list however I discovered the followingnat (dmz) 0 172.16.1.20 25...

Hi,We're in the process of migrating over to an ASA 5520 from a Pix 515. We've made several attempts and so far none have been successful.I've used the pix to asa migration too and combed thoroughly through the resultant config and everything looks ...

Is it possible to create the following design:1) Multiple Contexts: Customer Internal Network; Business Partner A, Business Partner B2) Customer net can talk to Business Partner A and B (from the inside)3) Business Partners can't talk to each other...

Hi,I have the following setup : TACACS --- LAN --- ASA1 ==== IPSec === ASA2 --- SW1 In my configuration, I can manage the remote ASA (ASA2) on its inside interface, through the IPSec tunnel with SSH. For that, I ente...