Network Security

Does anyone have a show command that will let me know what the module's model numbers are in a Pix 535? I need to do a parts replacement and don't have access to the box.Thanks for any help.

Hi,I have the following topology.1. My WAN router ADSL port is connected toa ISP,and the LAN interface is connected to a Manageable Layer 2 switch (VLAN 10 name public) with the a public IP address 202.X.X.201/29,then my ASA5510 outside interface is ...

Dear All,i had ASA5505.last time when it start to rommon and i was configure tftp to flash in rommon already but when i start up and i show flash it didnot see please see info as below:ciscoasa# sh flaInitializing disk0: cache, please wait...Failed.N...

Hello,I have problem in my fwsm placed in cisco 6500 switch. Attimes we have noticed that xlate is getting exhausted and when we put "clear xlate", its getting solved. But as its a core switch its crutual.FWSM Firewall Version 3.2(4).

I have a new 5505. My ping(icmp) requests are getting dropped from both the 5505 as well as the LAN its connected .How to enable the icmp ??

Hi,Suddenly my fwsm started asking me username and password, later it was only just password, I put the user name as "cisco"(by knowing its default)and old password. It logged in but not allowing me to run even sh run. it says some authorization erro...

Hi experts, I have ADSL internet connection with static IP. Behind the ADSL modem i have Cisco 871 with which i'm trying to make VPN tunnel with 3rd party organization. My ADSL wan interface has ip address x.x.x.40 and lan interface 192.168.1.1My Cis...

is Cisco NAC Appliance software can be configured as server or as manager or the software is different.meaning that is if i have Cisco NAC Server software can i configure it as manager or there will be additional requirements?

Hi guys. I am relatively new to PIX/ASA and am still learning my way around it. The thing is I came into a company where the IT infrastructure is pretty much setup already and management wishes to retain the current setup and are only open to small c...

Hi all,This is the first time I am trying to connect to our ASA 5510 via the ASDM launcher. When I connect to the default IP, the ASA ships with and try to connect via the ASDM launcher, the launcher just freezes with the message on the screen of Sof...

HiI have some problems connecting Cisco VPN client with PIX 515E 8.0(3). Here is the config below access-list nonat extended permit ip 10.10.10.0 255.255.255.0 192.168.34.0 255.255.255.0access-list inside_nonat_vpnclient extended permit ip 10.10.10.0...

Hi all,I have a Cisco 2811 with IOS Version 12.4(20)T and I need to enable IPS or IDS in this. What is the config for this?First of all, I need to know whether I can do IPS/IDS in my router as well..- Ribin

we are MPLS service provider, we need to deploy new services that when our customer bursting above the CIR we need to charge them for that bursting , we have CE to PE links like 10 M, SO so we are not using dial up or dsl links between the CE and PE ...

HelloWhen will the ASA 5505 support the IPS Feature?Thanks and RegardsLuke