Network Security

We have our ASA setup with 3 contexts. 1 management and 2 actual firewall contexts. The firewall contexts are working as expected however, we can not connect to the Management Context. I am able to ping the interface but not SSH to it. I have tried e...

What is the easiest way to log what private IP used a Natted public IP at specific window of time. We recently were informed that address 174.103.12.45 (within the scope of our public addresses) was scanning ports on a network. We have an ASDM 5.2 in...

Remote pix need to access my local network I am not quite sure on ACL needed. Below is the e-mail received from the remote tech. Also my pix config is attachedI'm attempting to ping your NAT'd IP address and this is unreachable on our end. Please be ...

I have an ASA 5510 running 7.24 that has logical interfaces configured.We will be allowing some outside vendors using our Internet link, they will be bringing their own laptops.I was thinking of adding a DMZ and just connecting their laptops to the D...

We have an ASA5520.We are going to now install theIPS card ASA-SSM-AIP-20.What additional license is required to allow the download of the signature files from the Ciso web site ?

Hello,I'm trying to configure a asa 5510 to forward the smtp port to a host on my network. If the destination host is in the same subnet like the asa and the gateway of the host is the inside ip of the asa, all works fine. Now my question, is it posi...

Hi,I have found 106021 log in the asdm and not able to understand what is for that. Can anyone explain. Thanks

For instance: crypto map TEST 10 match address TEST_ACLaccess-list TEST_ACL; 2 elementsaccess-list TEST_ACL line 1 extended permit ip 192.168.1.0 255.255.255.0 172.16.1.0 255.255.255.0 (hitcnt=501) access-list TEST_ACL line 2 extended permit icmp 192...

Hello all, i tried to look for information about the configuration in https portal in order to access windows files on windows 2008 server.I saw that cifs only support netbios, it's very strange because of new protocols in windows files now.So when I...

Dear all,Current running System Image is 6.0(1)E1, whether I can upgrade direct to 6.1(1)E2 or I have to go step by step like 6.0(2)E1 and then next. In addition I want to know if I upgrade, the current configuration will lose or not. kindlyupdate. t...

Hi, I have a Barracuda Spam Filter which accepts our incoming smtp and passes it on to our Exchange Server.For Outgoing emails the Exchange server sends directly out.I have static Nats set up as follows (external IP's replaced)Exchange Serverstatic (...

I have an interesting problem and I'm wondering if anybody else has encountered it. I have a customer where we've just installed a new Windows 2008 server. Everything works great until we try to communicate to XP clients on the other side of a L2L VP...