Network Security

Hi, We have two sites which are connected via IP Sec VPN STS Tunnel and yesterday it was working fine. Today we are experencing few issues like when we connect with Remote Server through RDC then after some time the session gets disconnected and same...

I have an ASA model 5510 on my client site. I want to use the Management interface to manage the ASDM and SSH connectivity to the box. I have configured the appopriate IP on the management interface and enabled it.For whatever reason, I am unable to ...

I am looking for some recommendations on how to implement two-factor authentication on SSL VPN and Cisco AnyConnect VPN connections.Curious what others are doing or what options I have.Thank you

Hi,I need your advice. tried to enable Firewall on the ISR using zone security but whenever i apply it on the interface (in/out)some of the ports like 3389 etc are blocked. Need to know if there is anything i need to configure to accept port 3389. cl...

I am trying to find the uptime of a vpn tunnel of a PIX 501 version 6.3.Does anyone know if there is a way to do this I would like to know how many days and hours the session has been running for.Thanks in advance for any help on this.

How would I go about installing and printing to a printer that is shared on a computer (WinXP) that is on the outside interface of my ASA5505?

Hello there! I have a ASA5540. I am facing a problem with it accepting the enable(exec) mode password. All the other devices are accepting the password except ASA. I do have configured the ASA with following commands for ACS:aaa-server abc protocol t...

Good Afternoon:Someone know if i can get reports from the Cisco Security Manager, as mayor port's used, mayor rules used, mayor denys, an graphics?If not is posible wich software can do it?

I have configured and integrated an ASA to my network.Inside----ASA----ROUTER-----InternetI have 3 servers in my inside network,one of them is a proxy server which all other users use. The 3 servers have both public and private addresses.I have done ...

I'm trying to configure an L2TP remote access connection in the ASA to connect from a Microsoft Windows XP / Vista client. I haven't found any example in Cisco website (only for preshared key L2TP connection) so I have a lack of information.First of ...

Hi, I am debugging intermittent hairpin VPN traffic between EZVPN clients, ASA 5520 is ezvpn server. I am trying to determine where the packet is dropped.From one client continuous ping to the other client is issued, the ping packets should go to ASA...

Hello,Trying to allow NFS access from a DMZ host to an Inside NFS Server, I got "% Invalid Hostname" Message when configuring Access Rule.That append when I add "eq nfs" to ACL.It's regarding HA 515E PIX firewalls, with context configuration and PIX ...

I have Cisco PIX (525) Firewall Version 6.3(5) with two interfaces. For testing purpose,One Pc is directly connected to each interface.From Pix i can ping both Pcs.But cannot ping inside interface of pix and pc(A) from pc(B) attached to outside inter...

We are about to replace our ole PIX 515E with an ASA5510.We are unable to direct traffic to our DMZ - several servers mulitple IPs, and to our Inside Network.Internet is working.Between DMZ and Inside too much traffic is allowed - We only want specif...