Network Security

I have a pix 501 with software version 6.3(4)PDM version 3.0(2).Problem: I was changing outside dhcp to static IP from PDM and pix freezes when trying to write to flash.Context: 1. the ISP had just changed our DHCP provided outside address with a new...

Hi,Is there a NAC CCA check to see whether the windows firewall is enabled or not?Thanks,Wei

HiI'm looking to have traffic sent to particular port (port 25) to be redirected to another ip and port.so if the tartget is:port: 25I'd like it redirected to:ip: 10.4.6.8port 25My question is how can I do this in pix, I'm currently run version 6.2.T...

Is there any way to effectively use a Pix 506e as a content filter? I see some example configurations involving an ASA 5500, but I was wondering if the pix alone will allow content filtering. We are a small business that is looking to restrict just a...

Hi. I have problem with ASA5510. I tried to flash from 7.2 to 8.03 - after reload ASA restart time after time and won't boot correctly. Hard reset? Some ideas?

I have recently started using the capture command in the ASA/PIX. I would like to find some documentation that defines the output fields in the captures. I have searched around quite a bit but am not finding much. Does anyone know of any documentatio...

Me again,Still having a bit of difficulty in the arena of configuring a PIX to replace failing hardware. I've gotten most everything else resolved, however, I'm in a bind with a unneeded timeout entry.These are the entries I have when I run "show tim...

Does anyone know of a good PIX auditing tool? I did a search and found the one by Algosec (still pending) and tried a RAT that had PIX functionality built in with no luck. I setup VMS 2.3 with the MC 1.3.6 and maybe I'm lost but I saw no auditing cap...

Hi !I have a probleme with a card csc-ssm on a ASA5520.I've put the url filtering enable . i choose some subjets to filter like games and porno. The card stop the games site but dont't block any porno site.i get the site url and put it on the Trend M...

Hi,I want to analyze traffic logs of cisco 2600. But I am getting only denied syslogs as below.<190>162384: Nov 22 22:12:48: %SEC-6-IPACCESSLOGP: list IN denied udp xxx.xxx.xxx.xxx(123) -> yyy.yyy.yyy.yyy(20), 5 packetsI have enabled "ip inspect audi...

Hi All,We need your assistance Issue: VPN Pkts get dropped. 1) A Site-to-Site VPN is established b/w Checkpoint & Cisco PIX. 2) Often the connectvitiy Flaps, i.e. the pkst get dropped.Error:Pix: Duplicate pkt on Phase 2Checkpoint: Virtual defragmenta...

We have cat 6509 switch with FWSM, IDSM-2, NAM modules. Customer wants all the internal VLAN's to be monitored by IDSM in inline mode. Customer has around 400 VLANS in datacenter and wants to monitor all communications between VLAN's. How do I monito...

What is the recommended minimum Cisco IOS Software that will support Cisco IPS Sensor Software v6 on the CAT6509

HI,I have an ASA 5520 with AIP-SSM10, I have configure AIP module with setup, but I dont have access through the ASDM to IPS, I only have access through cli session 1 comand.How can I acces the module through the ASDM.