Network Security

dear....i was able to use IDM before but after i upgarde the IPS from 5.1.5 image to 5.1.5E i lost and can not connect to sensor using IDM as before i enabled web tls port 8080 .....now i only use CLI to configure the IPS but i need to use IDM.....do...

HII have some branches which is connected HO . 501 pix configure in branch. only two server are static map by pix and this two server are access from outside.Now i have found new product ASA 5505.now 3 small branch are add my network.so I purches pix...

Hi, anybody knows any issue with QoS configuration over MLPPP ?TIA

Hello, i have problems in translating 1 public ip into 2 local web servers. I've already use global(outside) and nat (inside) command to set the dynamic NAT but i can't access web using that public ip.Before, i translate one of the local web server t...

I haven't had a chance to try this yet, but I need to NAT address that enter on one tunnel and exit on a different tunnel on the same interface.Can I use policy NAT where the source and destination is on the same interface?This is an ASA5520, can run...

I have a range of about 12 IP's xx.xx.xx.99-xx.xx.xx.110 that I need to allow http access to on my Pix. Is there a command to just allow that range so I don't have to set each one up seperately? Thanks!

I have a PIX 501 at a remote location and I seem to allow echo-repllies from the inside interface. I have tried ACL's and ICMP commands without success. I have attached a copy of the config.

Can anyone definitively tell me if netflow support is available for PIX firewalls?

What would be the best recommandation to configure FWSM:Router Mode or Transparent mode if I want to protect my Server Farm from all internal users inside my corporate company??Any advice are welcome..

Can someone tell me the difference between "static(inside,outside)..." and "route...." ?Thanks

Can the CSA-windows agent be used for Microsoft Vista as well?

Anyone know if the PIX includes the Oracle SQL*NET Application Proxy? If so, does anyone have a good link for setting it up.

Hi Guys,I have an ASA5520 with an interface to the internet on a /28 public network and an interface to a /24 public network - I will connect other interfaces to other networks in time, but I just want to get the thing working for now.Anyway, I have ...

I had a PIX 515E unrestricted with software version 6.3 installed.I upgraded its memory prior to upgrade to software version 7.x.I upgraded to v7.07NOW I lost access to PIX management web server (PDM).I read that there is no PDM now, but ASDM, fine.....

Hi,PIX is giving the following syslog when somebody browsing www.xyz.com. Since this message does not contain www.xyz.com, I am trying to get the website name through reverse dnslookup of yyy.yyy.yyy.yyy, but it returns datacenter ip address of a IP ...