Network Security

I have been charged with getting a pair of PIX-501 units set up and ready to be shipped to an off-site location.I did the initial setup, and configured the rules. Everything appeared fine, until I actually connected the WAN.Through the PDM, it shows ...

I have an 1841 with ADSL WIC and am tyring to connect a Win XP client PC to a remote network running a Windows VPN/RRAS server. In other words, I just need the firewall to pass through PPTP/GRE. If I use the PC with an analogue dial up connection I c...

Hi Folks:We have a Pix 515e with an Access-Control-List set only on the outside interface. We want a Win2k3 server PDC to obtain time via an Internet time server and have set the Win2k3 server to do so. NTP packets are either not getting out through ...

Dear ConcernRecently my company bought a 6506 switch with a firewall module.Now i want to update IOS for the FWSM.Please tell me the procedure to update the IOS.RegardsImran

Does a session command work on FWSM?

Can NAC appliances be monitored by CiscoWorks DFM ?

I have a PIX 515 running 7.2(2). I am trying to set up a public and a private network to separate the traffic. My PIX doesn't seem to want to participate in the VLAN. VLAN 1 is my private VLAN and VLAN 2 is my public VLAN. My Switch is a 3560.PIX Con...

Hi,Just would Like to find out if my cisco ASA is configured as multiple mode. Can the CSC SSM module support individual security contexts?

We have two PIX firewalls for two different functions, not failover.Both PIX outside interfaces are in the same VLAN with edge router interface.The edge router gets the default route from the PE router and distributes it to the intside on both firewa...

I am sending Netflows from my 6500s to MARS. I seem to get a lot of events that have 0.0.0.0/0 as the source and a lot that show that address and port as the destination. Are these broadcasts?Also most of my Netflow events are "Sudden Increase in tra...

I'm having a tough time trying to configure our PIX 515E to pull double-duty firewalling our two networks. Basically we have two inside (private) subnets (192.168.1.0 & 192.168.100.0) and two internet connections. One is a T1 and the other is a cable...

I have 8 IP addreses from my ISP. I want to use two of them on my new ASA 5505. I have configured one of the interfaces with our primary IP address but want to add a second. How do I set up the ASA 5505 to use more than one IP address on the same WAN...

Need to configure ASA 5505 to allow remote desktop session from Internet (outside) to server on inside interface.DSL modem is in bridge mode. I have a single live IP configured on outside interface (it's the only live IP I have for that site...leased...

I have recently deployed two ASA in Active/Standby failover mode. When a users goes to a site such as hotmail.com, the connection appears to be blocked, generating the syslog message below. Sep 17 13:12:19 gateway-fw-i %ASA-5-304002: Access denied UR...