Network Security

Hi,An outside company have done some configuration on one of our Pix 515e's to enable traffic from two of our public IP's to pass to a Citrix access gateway and a mail server.My question is really around the ACL they have applied to the outside inte...

Hi,I am a bit tuck on the WCCP method - there seems to be very little documentation on it for PIX. The commands are different to routeres. I tried this so far:wccp web-cache redirect-list Proxy group-list ProxyWS1000wccp interface inside web-cache re...

What is ?logging asdm? for? Does this command dictate if log messages are sent to ASDM? If so, why does show log asdm also show messages that seemed to be stored on the ASA itself? I?m confused if this is for sending log messages to the ASDM or if it...

Hi everyone.Anyone know the command for tur off ( shutdown ) ASA? I know just RELOAD for restart.Thanks

Hi!I tried to configure the ASA 5510 yesterday with the ASA Quick Start Guide but failed totally so I wanted to get a clean reset. I tried to reset it but something went wrong. Can't remember what it was but now when I try to connect to ASDM I get th...

I have an 837, very simple setup. It is working, but I want to know why it apears that some return traffic is being denied. As below trafic with a source port of what I am using, ie www and pop3.000150: .Jun 30 00:39:26.687 NZST: %SEC-6-IPACCESSLOGP:...

Hey...we are dying with our monthly reports. We have to reschedule them EVERY month. This could be resolved by a simple option that says "send on the 1st of every month". Is anyone aware of something that we are missing? We do 60 of these every m...

I have (C1700-Y-M), Version 12.4(16) and am unable to do:conf termip inspect alert-offip inspect name ftpfilter ftp timeout 30int fast 0.2ip inspect ftpfilter inIOS complains that is does know about "ip inspect". I've looked at the Feature Navigator...

I have a cisco Asa 5510. The purpose of this firewall is to block all traffic between two servers and only open port 5450. I have attached a diagram of the connection of the two servers and the firewall. Basically one server is connected to eth0/0 di...

I am attempting to configure my PIX 501 to port forward SSL traffic from the Internet to my SSL Concentrator located inside my network ? which has an address of 172.20.1.201In the PIX, I entered the following:Static (inside,outside) tcp interface 443...

Hi. I am not 100% sure this is the best forum for this question but here goes... Two ISPs are connected to two interfaces on our ASA 5550. G0/0 = ISP1 and G1/0 = ISP2. How should failover best be approached? I was told active / active via multipl...

Is it possible to clear all the interface counters? I noticed errors on my PIX's outside interface and wanted to clear them, but I couldn't find the command.My sho int output showed:MPA-PIX# sh intinterface ethernet0 "outside" is up, line protocol i...