Network Security

I seem to have stumbled on an issue in our test environment. Please see explanation below and relevant lines of the configuration.We have a PIX that is using 2 interfaces, inside and outside, no DMZ.The network outside of the PIX is 10.1.0.0/16. The ...

Hi all,I have basic question related to failoverof PIX. I know that when I want to doPIX failover both devices should be the same related to HW. What on the other hand is better or more useful? Failover with Cisco Primary-Secondary cable or throught ...

Hi,I have an issue with my Pix, during an FTP transfer the CPU goes upto 100% and stays there during the period of the transfer. When the transfer ends it goes back to 0%.The Pix is a 535 with 512MB, the two interfaces transfering the data are both g...

Hi,Should I use the PIX failover IP address of the outside interface as the default gateway for my external switch?Gavin

I'm installing an ASA 5505. I have public IPs for both the DMZ and the outside interface. Do I still need to set up some sort of address translation through the ASA or will it automatically go through to the DMZ? For example, if someone on the intern...

The ASA 5500 have there own management interface, but I? am not sure how to use it correctly. Lets say we use the outside inside and the management interface from the ASA.Outside: 2.2.2.2/24Inside: 10.1.0.1/16Management:10.2.0.1/16On the inside inter...

Let's say my PIX i 55.66.77.88 and my mailserver is 55.66.77.89. We get a high speed connection from Comcast, and they put a hub there, so one plug goes to PIX, the other to my mailserver. All my users are NAT, so they are 192.168.x.yWhat firewall ru...

Does anyone know if it's possible to add your own tabs under the summary section in the Cisco MARS web console. Currently there is "Dashboard" "Network" and "My reports" I want to add my own tabs for "Anti-virus", "Web Content filter", "Compliance" e...

Hello,What is TCP port 0 used for? I've searched around and can find nothing that makes sense to me aside from a programmer trick that I don't understand (I'm not a programmer). Inour MARS appliance, it shows up as TCP SYN Host sweep On Same Dest Por...

terminal server Cisco 2611 were installed. They run console connection to various devices. One device, a Cisco 6509 7.6 (12) is experiencing problems. When on command line the following error message is seen: Management logging failed. Low on memory ...

hi,how to access to the ASA's embedded IPS gui page? And how to restrict access to the MSN peer to peer applications? thanks...

Hi everyone,I am trying to implement a design with FWSM routing between VRFs, each MPLS VRF has multiple VLANs assigned to it. So, I am trying to put multiple VLANs on inside and multiple on outiside interface of each context without bridge-groups.Is...

Hi,I have two DSL lines, and I want to use at the same time this ISP with a Cisco Firewall.I have a Pix 501 but I think that is no possible to have 2 IP in the same Outside port.Maybe with ASA 5505 is possible? How can I do it? DSL-modem A----|.........

HII am using Pix 515 6.3my question is (PIX and ASA is different ?.like cisco pix 525 is pix firewalland cisco 55X0 is ASA firewall .)if i use 7.o in my pix 525 then it work as appliance ???.pls clear anyone.ThanksBiplob