Network Security

I'd like to know how can I configure a ACL to permit the isis routing protocol?In the acl there is no ISIS like OSPF

I am trying to setup a CCA CAM server, but the initial web page which instructs to install the license file isn't working. Has anyone else had trouble installing licenses on these machines? If so, any tips would be greatly appreciated.Thanks

Traffic allowed by acl is being denied, with the source port showing what the dest port should be. Here is the relevant acl line:access-list acl-cpt line 17 extended permit tcp 192.29.152.0 255.255.255.0 host 192.168.52.2 eq smtp (hitcnt=2)Here is th...

I have a PIX 515 win 6.3(3).Know I want to update it which version will be suitable and how to update plz kindly suggest me with a link from where I can see how to update

I've a variety of cisco switches (3524,3550,3560,3570, 6509) in our network, but I kept getting "partially success" in RME/Config Management/Archive Management. The error messaage is "Failed to fetch config using RCP.Connection refused: connect Verif...

Hi, When ever the device reboots, the no NAT command will get erased but not the access lists. that leads to create one more accesslist with no NAT command.ASA is running on Software 7.0 (2) with ASDM 5.0 (2)Does anybody come across this problem?Plea...

Hi, Can someone please send me a link to download Cisco Security Manager (trial version)I am a registered cisco user and I have a CCO account as well.thxraju+ 91 9867791104

It seems to me that an ACL wipes out the need for the security levels. Take a configuration of outside,dmz,inside interfaces. In the dmz there is a mail server that needs to talk smtp to all servers on the internet. So you create an acl allowing it t...

Let's say I have the following configured on my ASA 5510:Internet | ASA-----DMZ |Catalyst 3560 | LANinterface ethernet1.99nameif managementsecurity-level 100ip address 192.168.1.1 255.255.255.0 standby 192.168.1.14vlan 1exitinterface ethernet1/1.100n...

Can I configure both Inline VLAN pair mode and Monitoring mode in Cisco IDSM2 with ver 6.0? thanks in advance.

I can connect to the pdm from the inside using a web access with https://192.168.1.1, but when I try to connect to the pdm from the outside using the outside ip address, with either http or https, I am unable to get a connection.How do I make this co...

I have a PIX 501 with a corrupted configuration. During the flash load, it fails with a checksum error and then starts the reload all over again, etc, etc, etc...I have booted to the monitor mode and have attempted to upload a new configuration using...

Hi,If I configuring Cut through proxy from some user outside my network to my internal server, will the proxy authentication work only if I static map it to a outside public address or will it even work if i create at access list from the outside to ...