Network Security

hello everyone, the network scenario is as follow Internet Edge router--E0--Router 28XX --E0--ATM Router 38XX --fiber pvc--ISP. i wanted to divert my default route (internet traffic) to the ISP. The default routes has been added in internet edge rout...

What direction are the ACLs supposed to work for the vpn-filter command in a group-policy? We intended the use of this to filter traffic for this particular group to the inside subnet as well as VLANs routed through the inside/core switch. However it...

Trying to find out what class would cover the install and config for the NAC appliance if there is one provided by a learning partner. Would it be this:CCAD/MARS (Cisco? Clean Access (NAC Appliance) Deployment/Monitoring, Analysis, and Response Syste...

Hi,We have four remote sites with PIX 501's.They are approximately two years old, but we are unaware of how long this issue has persisted.We have found all of them incredibly sensitive to movement. If you stamp on the floor near one of them, it will ...

Dear All,I had ASA 5510 and modul SSM-10.Could you tell me, I want to reset default factory (configuration)on SSM-10 Because I can't log in Trend Micro Content Security.Best Regard,

I am about to upgrade my Pix 506 to software version 6.2(4) and would like to back up the current version 6.0(1) before doing so. I've looked around and I've tried to find any documentation on backing this up but have been unsuccessful. Could someone...

Here is the situation: I have Windows XP SP1 machines behind a Cisco PIX 501 (version 6.3(5)) using the Cisco VPN Client v4.0.4(D). These machines successfully connect to a VPN concentrator on another network using IPsec/UDP. Once connected the machi...

For over a week now I tried to figure out which product would fit our needs. I read manuals products, overviews and still I am not able to decide. actual: we have a LAN with Internet accessnew: we will install up to 10 servers each of this server wit...

Hi all, I use Cisco VMS 2.3 to manage FWSM. Now, I want to change password in FWSM. First, I use command line to change password in module FWSM (enable password xxx, passowrd xxx). Second, I connect to Cisco VMS to change password of FWSM (I change p...

While trying to upgrade, I received a timeout error using the copy TFTP command. I am unable to ping any internal host on the LAN from the PIX and cannot ping from any internal host to the PIX. All internal hosts still get internet access. Attached i...

Hi folks,I cant't get up a h323 trunk to another IP system. I've tried it on a local network and it works fine. Once I try to set up this trunk through a PIX Firewall (version 6.3 (3)) it doesn't work. One IP system is translated to a public IP addre...

I have a customer that is using a utility to remote to desktops in his network. Most of the remote sites are over IPSEC tunnels, some are over a transparent lan. The administrator can use the utility on the local LAN and TLAN sites, but cannot use th...

PIX515 has the following isakmp policy.crypto isakmp identity addresscrypto isakmp enable outsidecrypto isakmp policy 20 authentication pre-share encryption 3des hash md5 group 2 lifetime 86400crypto isakmp policy 30 authentication pre-share encrypti...

as shoown in the attached file diagramwe have multicast Application servers in inside all users in Lan1 & lan2 can connect to the multicast server i need to enable multicast on dmz & outside interface on pixwhat is the correct configuration you recom...