Network Security

I've just noticed since update of my sensor and MC to S235, that there are two new signatures 50010 WORM_SOBER and 50011 WORM_MYTOB. Are these related to the ICS OpSig signatures 50001, 50002 as there doesn't appear to be any info on them? Can I disa...

Can anyone tell me or link me to information on how to configure xntpd/ntpd in *nix (suse) so that IPS sensors can authenticate to it (as I understand it you cannot use ntp without authentication as of 5.0) and update their time?

what maximum upgrade i can do with this old firewall. the show version follows;Hardware: PIX-515, 32 MB RAM, CPU Pentium 200 MHzFlash strata @ base 0x300 0: ethernet0: address is 0003.6bf6.e1e8, irq 111: ethernet1: address is 0003.6bf6.e1e9, irq 10...

Hi All,Hoping someone can help me with this. In the Cisco press book its shows the performance as 1000 Mbps with the XL card, however on the Cisco site it shows at 800 Mbps, which one is correct?Also is the the performance for the whole device or per...

hi, few very basic questions about ASA series. In PIX it easy to configure access control with just one inbound ACL on each interface, and with simple rule of editing ACL witch is closet to source. Now in ASA we have both ?in? and ?out? these are con...

In order to validate our installation process, we try to install LMS 2.5.1 on a virtual server over Windows 2003.Everything works properly except when we try to launch "validatupdate.exe" file to validate with old CD. Each time validation failed.Does...

i have two 2800's that are running GRE/IPSec site to site VPNs...from the spoke site i would like to markdown/ratelimit down a particular traffic flow destined for the headend....whats the best way to do this?? Can someone show me a template?basicall...

Hi!could u plz give me a usefull link that contains various config for various scenario.

hi everyone!is there a way to permit voip traffic in a pix access-lists? that is permit only udp/rtp even port numbers?

It's been my experience that iTunes streaming of Internet radio stations is being interrupted by our AIP-SSM-10 running in inline mode. There are no alerts generated for the source or destination IP addresses in question. As soon as I change the clas...

I am installing lms 2.2 on Win2k server.When the server is not plugged to the network the installation is fine. But when it is plugged to the network the daemon manager will not start after any shutdown.What could be the cause of this problem?

I would like to know the command how to remove the PDM from PIX 515. Thanks.au-syd-fw# sh versCisco PIX Firewall Version 6.3(4)Cisco PIX Device Manager Version 3.0(4)

Has anyone had success on creating a site-to-site vpn with a Pix 501 and a Linksys RV082? I am having an issue establishing a connection. State on the pix side says: MM_NO_STATE Both sides are setup for 3des/md5. pre-shared key. Any ideas?

question is same with the title

Plaese help me reset password on ASA-AIP-10-INC-K9 module.Thanks,