Network Security

Hi,We have a VPN tunnel between an ASA and cisco IOS router (remote site IP 10.14.0.0. /16 ).We would like to monitor the remote site hosts from our management segment.Our management segment is separated from the ASA via a Checkpoint FW.Management in...

I read (can't find the document again) that you can run active/standby pix failover set on two different versions as long as the first two digits matched up - i.e. 7.0.1 and 7.0.4. I upgraded my secondary pix515 to 7.0.4 and want to wait until at lea...

Our NMS is getting hit by lots of Authentication failure traps from our Cisco devices as IT insist on snmp polling our entire network.To stop this I have put an ACL on the snmp-server community line. ieaccess-list 58 permit z.z.z.z 0.0.0.255access-li...

Hello!How can i copy a config file from a tftp server to a Cisco PIX 501 flash?I mean like in Cisco IOScopy tfpt startup-config.

I'm a TAC Engineer preparing for CCIE, although I might take CCSP exams, but I don't have any knowledge about IDS/IPS. Could somebody please tell me what is a good resource for knowledge on IDS/IPS from the CCIE exam point of view?Regards,Kamal

We currently are running on a PIX 515 version 5.2(3) and need to upgrade to a 515E. When I duplicate the configuration to the new system I cannot access the DMZ zone. Everything else works. Any ideas?ThanksWe are running version 7.0 on the 515E

Mu understanding is that if you have policy based NAT in your config you cannot configure using the PDM on v6. We are about to install VMS, and I'd like to know if VMS will have the ability to support policy based NAT on pix v6

i am new to cisco ips systems. we import the text output from the sensors and pull them into our gui. i am trying to figure out what the expression means. it looks like just a standard output, but i would like to know

Is there a way I can use just a browser (no java) to request only a specific eventId (alarm) from a sensor? XML results are fine. Thanks,Matt

Hello,With my other Cisco devices I have scripted something which saves the running config using SNMP & TFTP once a day. I am looking for a way to achieve the same with the PIX. It doesn't have to be via SNMP/TFTP, but I want to make scheduled, autom...

I would like to downgrade an active/active license to active/standby on a PIX-UR-BUN version 7.02, pls help

Hi all,I am working with Cisco Trust Agent 2.0.I do not find Posture Plug-ins for Symantec Antivirus?Please show me where I can find thest Plug-ins?Tks

I've got an old 1605R that just crapped out on me. The only thing that I have available with two eth interfaces is a pix 506.I know I can set it up to route between two networks and then allow ip any any between the two. What are the cons to using a ...

i have pix 7.0 .there are pptp server and pptp client on the two side of pix.i know pix 7.0 doesn't support pptp.but if it's also can't let pptp throughtout? how to config pix 7.0 to permit pptp connection through pix.thank you very much.

Hi everybodyThere are 4 vlans in our network.In the one of the vlan, there's a file server.Users in the others 3 vlans should be able to access this file server.How can I route traffic to the server ? The network design is as follow :internet -------...