Network Security

Hi,I am going to change the Ip address, interface name and security number, access-group name on the interface and take out the ospf routing on that interface on our pix firewall.My question is, in doing these changes, will the interface i will be wo...

lost my conection to the pix using the PDM, access deny error after i enter the second password. It seems like it has to do with java. I still conect perfec trough the console any sugestion apreciated.

Hi All In our network we have configured tunnel over NAT setupthis tunnel is flapping continuouslywith log meesage CRYPTOSESSION UP & DOWNAttaching the configuration detail on the remote Side routerthere is Crypto Seesion Up & Down log in the Hub Sid...

Getting the following error when attempting to upgrade IDS 4.1 to IPS 5.0:"Exception Error: Error -- Attempt to select Item, "string-tcp" failed [Item::unionItem]"This is on an IDS-4210, sig version 4.1(5)S236Approx 13GB free disk space.

HiI am implementing NAC, I need to know how configure a posture validation rule with 15 Hotfixes, I can use wilcard.Thanks

Is there an IDS signature release for the 4.1 platform for this vulnerability ?The bulletin only mentions the 5.x platform.

We have an in-house vulnerability scanner that regularly does port scans and we don't want to see events when the source IP is from the vulnerability scanner.We tried a network access rule but it dose not work.1) Network Shim is enabled2) Network shi...

i have a cisco1841, with 2 ipsec tunnels to 2 branch offices, and i have set it also to be an easy VPN server, clients connect to the main office network but can't access any data on the branch offices servers.please help as it seems i am missing som...

Has anyone had any issues with the new IPS 5.0 Device Manager. On the majority of my IPS Sensors, after the initial login and launch of the application, it just hangs at the 77% point of the parsing configuation stage.Anyone had similar issues?

I am running with Sensor 4215 with IPS version 5.1 and IPS-K9-patch-5.1-1p1. I was able to use Web interface on TLS. Since last week I am unable to connect to the web interface. Everytime I try to connect to it it loads itself to 77% and give me an e...

Does anyone have any links or suggested reading for PIX troubleshooting techniques, methods, whatever?I'm thinking of the scenarios where X phones up and says I can't Y anymore, it must be the firewall.This would be for the CLI as a by the by, but po...

Hi everyone, I am hoping someone can point me in the right direction here. I have just plugged in a Pix 535 (with an allow ip any any access list on all interfaces) into the core of our network. I have also configured it to not do any NAT's and purel...

We have configured the PIX firewall to act as a default gateway.......ICMP is working fine with access-list 102 ip any any internet is working fine but when we give access-list 102 permit TCP any any eq www and remove ip any any internet is not worki...

hi,Currently we are using pix version 6.3(5) 506 model for our email server.Policy rule pretty simple, object-group service Email-ports tcp port-object eq 995 port-object eq 456 port-object eq smtp port-object eq 8188 port-object eq pop3access-list o...

Hello,I currently have 2 ASA 5520s in an Active/Standby configuration. I have set up 2 VLANs on the ASA corresponding to port g0/0. Config:Int g0/0.1vlan 10nameif Outside66ip address 66.38.xxx.xx 255.255.255.224Int g0/0.2vlan 20nameif Outside64ip add...