Network Security

Hi,I have a PIX 501 at a remote site that I cannot get into now. The users report that the power LED is flashing. I could not find any reference info on this.Thanks - Wayne

Hello,I have been told I need to add some routes to the PIX to allow some IP addresses to pass traffic. When I try to add the route the PIX says "cannot add route entry" Below is a sample route I am trying to add. Can anyone tell me what might be wro...

Hello,We have the problem that our Cisco PIX 501 6.3(4) does not develop the VPN tunnel any longer, after the Provider disconnect the DSL line after 24 hours and rebuild it. Afterwards the tunnel seems to stand however it gives no more connections. O...

IDS2# sh version Application Partition:Cisco Systems Intrusion Detection Sensor, Version 4.1(4)S146OS Version 2.4.18-5-phoenixPlatform: WS-SVC-IDSM2-BUNSensor up-time is 11 days.Using 1946804224 out of 1979682816 bytes of available memory (98% usage)...

Hi Given below is the ips version :Cisco Intrusion Prevention System, Version 5.0(2)S152.0OS Version 2.4.26-IDS-smp-bigphysPlatform: IPS-4240-K9If I will re-image the sensor to lower ver which image & service pack should I use and what is the right p...

hi i have a pix 6.1.I am having some problem with my tacacs+ server. now i want to troubleshoot but i dont have (debug aaa) commands. So can any body tell me the other way to troubleshoot.

I have 2 Different ISP links connections on pix(IOS 6) IOS outside and intf2, which I need to run VPN and want the links to be in redundancy,please asking how to configure.

This afternoon my pix appears to have stopped accepting connections from vpn client software. All of my pix-2-pix tunnels are still up but I can't get and clients to connect I have a case open with cisco but am awaiting a response from the engineer. ...

I am planning on setting up a PIX 501 for PPPOE and have run into a couple questions. I am looking at documentation at http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/products_configuration_example09186a00801055dd.shtmlThe reason I want...

hi i have a question,i have a pix 501.Now on the inside interface can we have both public ip+private ip's. internet<-->router<-->pix 501<-->(public ip+private ip)Pleas tell me how it can be done if possible.

The latest version of IPS MC, v2.2 does not seem to store the last event position when restarting the CW processes. The result is that CW retreives the complete list of events on all the sensors event-store, no matter of the alarms have already been ...

I'm new to this so please forgive my ignorance. My question: How can I set up two VLANs that maintain security between the two (VLAN1 cannot access VLAN2 and vice versa). We have a Cisco 1721 router (ver 12.3) and a HP Procurve 2524 switch. Do I have...